Search results

This one looks perfect for the application. A little pricey though. http://www.homedepot.com/p/RIDGID-1-2-in-Spade-Handle-Mud-Mixer-R7122/100523157?N=c27fZ18gZ1z141kh

This conversation has steered me away from the HF model... What's the consensus on this one: http://www.homedepot.com/p/Milwaukee-8-Amp-1-2-in-Magnum-Drill-0299-20/100026817?N=c27fZzvZ1z0wjscZ1z141kh#.UnoghhDOQwA I'm brewing this weekend so this serious decision needs to be made. :confused::)

Thanks a lot for the reply and information. That's what I was assuming regarding the high speed crush. I'm going to go out and get the drill you linked. ;)

Hello, I'm using the Barley Crusher mill will a corded B&D drill. The drill will mow through the grain at high speed. I think it's spec'd up to 1350 RPM. My question is if running at too high a speed will actually created an unnecessary amount of husk dust and small debris? Thanks, Jim

I stand corrected. After completely dissembling and ruling everything out in the valve itself, I finally tightened the valve barb connection further. Problem solved. I don't quite understand why it was valve position dependent, but it's fixed. Apparently, certain valve positions maximize the...

Thanks a lot for the reply. I don't think it's the valve/barb connection because it is dependent upon the valve opening position, and because it does not drain at all from the valve side when closed. I actually have 2 identical 10 gal units, one for mash, one for sparge water. I just tested...

Hello, I'm using a 10gal cooler with a ball valve as a mash tun. For some reason, the ball valve is sucking in air during the recirculation and later the transfer of the wort to the kettle. I initially thought it was coming from the hose/valve connection. I tightened that with a hose...