Search results

pics of the keezer setup? willing to sell separately? how much? (can pm me if you prefer)

Good though on the overheating. I can add a 12cm computer box fan I have laying around to vent it more aggressively

It's a serving tray from a restaurant, catches the drips nicely. You can get them on Amazon for cheap

bumparoo

regular dry pellets, bought a pound and used most of it 2 years ago I doubt it's pbw given how much hot water I rinse through everything new hops and grain purchased....hopefully not a waste

probes are cheap enough to have two and just switch inputs on your controller.... i don't need a temp probe to boil. I use my for mash (recirculating) and for prechill for a hopstand I mounted it on a modular piece that I can put anywhere on my plumbing (camlocks) Tadapter by staticfritz posted...

i used it previously without an issue, and my wife thought it was god awful too. i mean seriously, it's bad enough that i'm throwing away like 10+ gallons of beer now....

:mad: so I think i found the culprit after making two awful batches of ipa. Anyone have something like this? first bad beer was a basic IPA, but a first time brew on a new EBIAB setup. since it was really just a 'test' beer, I used a bunch of hop cones I found and froze last year to dry hop...

its not fancy, but it's very low profile and much better coverage than just a 'flap' of matal overhanging the pump

updated brew day! https://www.homebrewtalk.com/forum/threads/my-relatively-small-240v-panel-ebiab-build.641155/#post-8267719

Trader Joes juice bottle! cut a hole in the bottom and slot along one side, left the cap off for better ventilation

second brew day on the books finally, worked pretty well! I am just in awe of how quickly this setup heats and chills water. And it's so much easier to just clean in place w hot pbw and a dish brush Upgrades/mods: - Modified a new corona mill, ran it off a drill on low speed for my grind - rare...

several people have threads on their builds. some as simple as on/off switches to fully automated controllers Mine is a relatively simple layout electrically that gives a lot of nice manual control My wiring was only tough because I squeezed it into a pretty small enclosure...

bumping it up

central welding in sodo/georgetown and in ballard will both do 5, 7, 10lb cylinder exchanges for CO2

pump through a counterflow chiller backinto the kettle

1

:mug:

still available