Search results

Hi, I’m replacing my beer lines in a kegerator. This may sound like a dumb question, but how to I get the line off the elbow? And once off would I just use a screw clamp to connect the new line to the elbow. Mine isn’t barbed. See attached. Thanks

Just an update for you guys! Bought the above mentioned muffin fan and now we are at 34 degrees. Best of all the IPA is pouring perfectly. Now just need to make sure it doesn’t drop too low. I’m going to turn the thermostat down and hopefully it equalizes the temp at some point. Thanks for all...

Exactly! Once I find something we like then the goal is to do the whole keg

Yes, I’m actually going to buy a bunch of different flavor extracts and use droppers to flavor the drinks individually. Go Cubs!

Here is a better pic of the frost on the old plate.

You guys are awesome!

Before I adjusted the torx screw on the thermostat. It would develop a very thin layer or frost, like if you touched it your finger would stick. When I adjusted it there is a very noticeable amount of frost on the cold plate and the fan ran longer. See attached image of the cold plate. In either...

So because the cold plate gets cold and even frost on it I assumed that it isn’t a refrigerant issue. Is that wrong to assume?

I have a 8 year old Summit kegerator. Been using it on and off. I can’t get the beer temp below 50 degrees. I’ve always had foamy beer. Recently I decided I need to figure out what’s going on. -I replaced the thermostat, adjusted the torx screw to lower the temp -changed out the faucets to...

Great! So .75 gal of vodka and 4.25 gal of water?

Hey guys! Looking to keg my first hard seltzer for the non beer drinkers (my wife). Looking for a basic recipe to make a Vodka seltzer. I’m not worried about flavorings right now as I might just keep droppers of flavors on hand. My main concern is ABV. Looking to hit around 6% ABV. In a 5 gallon...

Perfect!!! So get 2 of the female flares and 2 of the QDs one for beer and one for gas. Thanks for your help!

Hey guys, Sorry if I'm not using the correct terminology. My beer lines have hex connectors that thread right into a sankey tap. I would like to use the existing beer lines to connect to a corny keg without removing the ends. Is there a coupler or adapter that would connect to the female hex of...

so if the tank does not have a liquid out port then I'd need a tank that has a syphon tube in it?

I own a restaurant and have 50# tanks that are used for dispensing soda. I wanted to know if I could use one of those tanks to fill my 5# tank in my kegerator. I'm trying to avoid having to drive 10 miles away to a fire extinguisher company each time to refill my 5# tank. Is it possible and what...