Search results

I have the above mentioned kegerator, and would like to drill a hole in the side to feed a beer gas line inside. Currently, I have a CO2 line running through a hole in the lower back wall. That hole was already there, I think it is used by the thermostat. For beer gas ( CO2/ nitro mix), I...

I'm currently playing around with my kettle pickup tube, trying to minimize losses in the kettle (wort that is left behind after draining the kettle from the bulkhead). I have a 10 gal flat bottom pot, and was using a hop stopper with the stainless steel centre pickup tube. I thought I was...

I'm in the process of gathering parts for my electronic brewery control panel build, and looking to get some feedback and suggestions. I will be controlling two heating elements on two separate circuits, a 20A 120V circuit for a 1500W RIMS tube and pump, and a 240V 30A circuit for a 5500W brew...

Hi, I am going to be building a RIMS setup soon, and I had a few preliminary questions that I didn't find answered elsewhere, so I thought I'd post. I've attached a drawing of my basic setup. I've never used a pump or RIMS tube before, so I wanted to check on a few things. 1) To "prime"...

brewed a pumpkin ale 16 days ago. I grabbed a sample for the hydrometer, which was 1.010, which is about right where it should finish. In tasting it, I found it was slightly carbonated. If I swirled the jar, it fizzed up a little, and you can see the bubbles moving to the top. It tastes very...