Search results

Standard stainless keggle with ball valve and thermometer. Very clean cut. Pick up only in Fresno, CA. $150.00 PM me if interested.

Sold

Selling my triple tap kegerator. It holds 3 corny kegs. Taps are brand new, and unused. All three lines are new. Two lines are unused and one has seen only one keg of beer run through it, but has been cleaned. Located in Fresno, CA. I can deliver with-in 200 miles for a fee. $350.00...

Glad to hear you're still ebrewing. I'd love to have a pint of that. AR's huh, I hope you're not feeling disgruntled.:)

8 minutes seems pretty fast vs my 35, but that's a pretty big element. Is it a 120 or 240? Maybe I should get a bigger element. Do you vourloff before recirc, or do you even have issues with grain clogging the pump? Add rice hulls? If so, how much?

Just finished building my new RIMS tube. I used 2" dia stainless, with a 6" nipple between the Tees. The element is a 120v,low density 1500 watt. Had some trouble finding an element that fit the NPT threads on the stainless. But in the end, a few wraps of teflon tape did the trick. So the...

Perfect...I think that's what I'm going to do.

My Co2 Story: My neighbor who works fire suppression offered to bring home a 5lb tank. He put it in his sedan, then got called back inside work for a while. He got back in his car and proceeded to drive away. He started to feel bad, and difficulty breathing. He was able to pull over and get out...

So far, I'm looking to drill my A.S. hole about 2" down from where the keg roof starts to curve. I hope this is far down enough to reach lower gravity mash scenarios. Schristian, did your valve open and close when you moved the float up and down manually?

Yes, there is a variation, and the only way to be sure of a good fit is to try them out before purchasing.

I'm putting together a Mash Tun from a Bud type keg, and wondering where the best location to drill the hole for my Blichman Autosparge. The autosparge is adjustable for various grain bed heights, but there are limits(upper and lower) that it can reach. I only do 10 gal batches, and plan to...

I'm building a RIMS tube with a 1" heater element. My stainless end cap has a 1" NPT thread, but heater elements have "Straight Pipe Threads" I brought my end cap to a couple of big box stores and a plumbing distributor store, and tried to fit their elements in my end cap. I could never get more...