Search results

The inserts link has a configurator. You make your selection based on tube size, tube wall size and stem diameter/thread pitch

No, they have 3: Left, Right, straight through

We only use 4" casters. Anything smaller is a waste. Once you have rolled a stand around with 4" casters you want nothing less. Inserts Access Casters Caster City

This might help you decide

Find your valve vendor first and find out what they carry.

3 burner 2 tank 30 gallon???? what kind of burners? A banjo / BG-14 is adequate. Heating your mash in the kettle is dependent on your mashing style which you never stated. Is it direct fired, HERMS, RIMS or???

wow... just wow that quote should be on your sig

Yes and No 3 way where you need it and 2 way where you don't. 3 way is less expensive than 2 - 2 way and requires less wiring than 2 - 2 way valves.

Nice kettle!

10 gallons in 35 minutes is a little slow, not bad. Are the flames nice and blue? I ask because often there isn't enough air above the burner for proper combustion.

from what temp? must be the sucky gas lines :tank:

Hearsay until we see photos... :p

Use a PID and not the Ranco. A simple furnace gas valve, thermocoupler and standing pilot work fine. We use a more expensive method but it is the safest and easiest to install. We use a 'smart' gas valve with a hot surface pilot. Built in safety. Also, do not run gas through the frame if you are...

Question Red: are your neighbors recirculating their wort? If so, they are defeating the whole purpose of a CFC or plate chiller. They are heating their wort back up.

I doesn't get any simpler and the inserts are rated at 1250# each

There's no reason it shouldn't work.

That's the unit I use. I bought mine at MoreBeer (2 miles from home). I like MoreBeer, their showroom staff has recommended customers buy stands from us... :D

Neither the element listed at Lowes or at High Gravity state ultra low density like this one. You might want to check that out before you decide to purchase. (BTW your Lowes link doesn't work)

Hi hear ya bro! Gone through a lot of parts getting our systems to where they are today and we are just getting started. Valves, plumbing, switches, scrap steel.... Fortunately, we have a much better idea nowadays and 'most' stands are cut and dry.

It will never work, the HLT is at the wrong end... :D