Search results

No joy :( about to reformat card and start again

They all seem ok, this is what they look like if i check them. I tried rerunning jessie-setup and also ran the lines individually, still the same.

Retried, my permissions to this directory and it's files are ok.

Clearly I have something wrong somewhere as when I run the Arduino IDE as root I can select the serial ok, when I don't run as root its greyed out. If I select the serial when in root it is displayed in the bottom as Alamode on /dev/ttySO but if I close and reopen as not root it is still not...

It just returned to cmd prompt, after some googling I tried running Arduino as root and then this was no longer greyed out. I re-ran the above command and all good. Do I always need to run as root or is there some permission I need to change somewhere?

Yes enable_uart=0, where am I supposed to execute the command?

Yes I did, double checked too. I think something else might be trying to access the serial port rendering it unavailable.

Damn I feel like such a noob but I have another question. Soldered up the alamode and fired it up tonight. All good until I try and select the serial port and the menu is greyed out. Did some googling bit can’t work it out, anyone experienced anything similar?

Oh ok, I was planning on supplying power to the Alamode board and powering the pi from there as it was suggested on the raspberrypints site due to load from the flowmeters, I guess its just as easy to power both with their own supply.

Hey, my Alamode board turned up today and reading through the instructions there is a warning regarding supply of over 5v and a recommendation to install a voltage regulator NCP1117ST50T to the board to limit to 5v to avoid burning out the board. Has anyone done this mod? Recommended or not...

Excellent, thanks. This worked. dos2unix ./* then sudo ./jessie-setup

Thanks for the answer, I had found this and followed the step variations for 5 and 7 but the Alamode installation changes are referring to a RPi 3, I am running mine on an old RPI B which I had laying around and seems to be running all the software of with the exception of I am having trouble...

Hi all Excellent thread, I had tried setting up this on from the Raspberrypints website but everything was failing until I found this, needed an older version of noobs and a couple of other things I found here, thanks. I have run into one problem, apologies if anyone has already posted. When I...