Search results

Not sure if this helps, when I first opened my device after upgrading to 1.1.0.15, the dual throw port was set to zero and I changed it to None. As there is a zero port, maybe that’s causing this issue. @BrunDog, existing devices are defaulting to zero for the Dual Throw Port instead of None...

Absolutely. Will report back when done. EDIT: The Dual Throw Port is sticky between openings of the properties dialog. It initially came up as zero (0) but I changed it to None and that is being maintained. No wiring changes to my panel and that CZH relay is now powering on. I did have to...

I did that about 5 times yesterday. My first instinct is that I've done something wrong and want to recheck. Once more for the team... Create a Digital Output device and Dual Throw Port is blank. Set it to None. Click OK. Open device and Dual Throw Port is blank again.

Funny thing. I did that last night because I noticed the empty field. The value does not stick for me. When I close the dialog and re-open it, the field is blank again.

Yes, I always have the wiring map on a monitor when doing this as I don’t trust my memory enough to try to shoot from the hip on this stuff. 6-1 is port 29 on the Mega UniShield. I’ve disconnected the wire from the UniShield and tested voltage that way to ground for both D & P pins. I get this...

Yes, VB is the bank and it had the 5 VDC and now 24 VDC applied to it. EDIT: I checked 6-1P through 6-4P and none of them is putting out any voltage.

Alright, facing opportunity #2. I am trying to get my CZH-LABS DIN Rail Mount 4 Channel 12 Amp Solid State Relay SSR Module running. I have each of the IN+ connected to UniShield ports 6-1D thru 6-4D. The IN- are connected to ground (AC & DC tied together). I don't get any Digital Output voltage...

Update: After Peter worked on my issue for a bit, we determined that the Pt100 MAX31865 board, one of a set of 4 I purchased from Amazon but were delivered over a couple of weeks, was a Pt1000 board with a Ref Resistor of 4300 (4301 on the resistor). The initial value in calibration for the...

I figured that was the case. Yes the UniShield I picked up from you in FL back on 11/14. Haven't changed the firmware (BruControl v45O.E). This is all that is in my controller log with today's date... 14:22:52.891: File created 12/20/2020 14:22:52.907: Device 'Garage BCU' @ 192.168.100.25 =...

No changes on the Calibration or Appearance tabs. Here's the General tab...

Hi everyone. I'm new to the forum and nearly done with the build of my controller. I have a problem I haven't seen asked in the first 65 pages or so of this thread. When I create any number of PID elements and assign a working PT100 as the input, the PIDs never display anything other than 4...

I'd like to win either one!

Shopping now...