Search results

Ahh. Thanks for that clarification :) The sensors are not tilting down but are in level. I'm also gonna install them with quick disconnects. They just haven't arrived in the mail yet.

I have made the GUI myself but it is running on a Wago PLC with their e!cockpit software

I registered a QUOTE on alibaba.com and got in touch with a manufacture there. If you want... I can send you a PM with the contact info :) They made the sensors and the cooler ribs (to be able to handle boiling fluid) on my specs.

The temperature in the BK is monitored but I haven't done any tweaks regarding the correction factor or the density. That would be an awesome addition to the BK setup. You got some additional info to point me in that direction? I have been testing the volume control for the HLT and it...

I run a All-In-One touch computer in my setup. Fits like a glove in my PLC control panel :) Also got a dual screen computer setup for my YouTube livestreams.

As you can see I dropped the load cells after a couple of batches ;) Using pressure transmitters now

This weekend I noticed that I haven't updated this thread for a long long time! So much has happened since my last post. So let's do a recap :) This spring I finished up my new brewhouse in the garage. Finally the Hop Rod Garage is... in the garage. I know got a insulated room that is...

I'm trying to figure out how the API is working. Could someone give me some URL examples like how to: - Set control mode for a device directly (off, beer constant, fridge constant..) - Select a beer profile directly by name

Seems like the operation is OK now. I changed the 10k resistors to a 4.7k on both cards and its running good now. Maybe early to to say its fixed - but looking very good. Now the cooling runs without stopping after a few minutes. And all the "dips" in the graph are gone - so there was som...

Thanx! Will the reset of EEPROM clear all the sensor assignments as well or is the config kept?

Did you sort this out? I got the same problem. My time i 2 hours off (live in Norway)

My new installation is driving me nuts! I got two wemos boards and two breakout boards made and connected to my new fermentation chambers. Tried both serial and wifi firmware but find the serial much more stable. But the first problem is the card changing ports during reboot of the Pi. Argh...

Is there a way/URL to only show the black LCD panel for each chamber? I'm thinking about integrating Fermentrack in my new Wago e!Cockpit PLC controlled brewery.

Upgraded to the latest and renamed one of my chambers to something with norwegian characters. "ascii' codec can't encode character u'\xe6' in position 2: ordinal not in range(128)" Same error

I did the same mistake this weekend - Norwegian characters in the name. "Back" in the browser saved my ass this time.. :p

Running 0.81 serial. Did a flash_erase before flashing 0.81 using esptool/PI. It seems to run a kind of Wifi SSID which I'm able to connect to. My mac gets an IP (192.168.4.2) but it does not make me able to run the Wifi setup (the popup) to configure it to my own wifi. If I flash the...

I did this and seems to erase everything :rockin:

Another question: Is it possible to reset the device counter? After adding and removing devices I now got /devices/6/dashboard/ and /devices/7/dashboard/ How to reset this so I get /devices/1/dashboard/ and /devices/2/dashboard/ ?

I'm now testing the serial firmware instead and it seems to work OK. But I am still able to ping the wemos mini D1 on their IPs from when I was running the WiFi firmware. So it's firing up the WiFi when running the serial firmware. Edit: Did some more testing now and erased flash before...

I've just ordered all missing components to be able to hook up fermentrack for my new fermenter chambers. Just one question - what do you guys use for the door sensor? This is the only part that I haven't ordered yet.