Search results

The other discrepency is the EZBOIL manual states the two red wires should be connected to the terminals 3 and 4. The white wire should be connected to terminal 5. I have 2 Blue wires and 1 Red. So do my blue go to terminals 3 and 4, and red to terminal 5? Thx

Hi there I have gotten my 3 wire RTD P100. It has 2 blue wires and 1 red wire connection. You can see my XLR connection accepts the 3 wires plus a ground. Question how or what do I connect to ground? Is there a standard connection for the 2 Blue and 1 Red terminal on the XLR CON...

Returning the item through AMAZON and seller is going to send new one with grounding terminal. Great customer service so far. thx

OK I see it on AMAZON.COM vs AMAZON.CA. Will contact seller. thx

Where do you see that comment. I definitely do not have a ground screw. Just the 2 hots. Thx

Hi I just ordered this. https://www.amazon.ca/dp/B01NBNQU82/?tag=skimlinks_replacement-20 It only has 2 wire connection on the element for the 2 hot lines. No grounding screw or way to connect ground to it. Then the plastic housing screws over the wire and connections. Should this not...

Where is the option to order without their PID? Thx

I am looking at this kettle and pump which already has 1/2" NPT fittigs so I assume I would order the RTD with 1/2 NPT as well. Now question is how long of a probe. I assume I need some kind of TEE fitting so 1.5" probe would do? Thx

OK I get it. That's pretty smart. No need for separate switch and POT. I went to Auberins started to put together my list of parts. A few questions I can use some help with. In the schematic above it shows a Pump Switch as a SW1 or SW16. Looks like a double throw NO. But only one side...

Dumb question, I get how the EZBoil works in mash mode by turning the SSR on and off as required. How does it work in Boil Mode? By it lowering or increasing power to a SSR which is off or on, has no bearing on the high power side? Thx

HI there I am new to this forum and been fighting with a Sanke Keg I purchased off of Kijiji. Here are some pics.. The retaining ring does not align with the slot in the keg. So using a screwdriver in the slot is trying to pull on the lower loop of the ring. I tried a pulley puller and...