Search results

I can confirm this I had the same problem and connecting pin 7 to the ground keeps the I2c display on. Just another question is BrewPi Remix supporting iSpindle? I just received my kit today and I would like to test it with my next brew.

Great shorten pin D7 to GND worked fine for me. Thanks again!

After receiving my 3th arduino uno (first was a clone, second never arrived and the third found in a local store), I finally got my own working BrewPi Remix with I2c LCD and 2x SSR. Can't wait to tried it with my next brew. Just a small question about the LCD, the brightness drops after 40sec...

A colleague advised me to use SSR instead of relays because mainly for power consumption but they are triggered at low voltage instead of the relays so I probably need to find a solution for that. And because I've already bought them so I prefer to use them instead of relays. Many thanks for...

Thanks for the info! I will be using other parts like Solid State Relays and an PCB experimental board so I will be using DuPont jumper wires to connect everything together. Maybe in a later stage I will try the new shield. As already mentioned I'm pretty new here and I still need to read a...

Do I need it to start the installation or can I buy and add it later? I already have an 20x4 I2C LCD currently connected directly to my RPI.

OK I've already ordered my arduino so I'm convinced ;-)

Donnie, thanks for the quick reply. I can confirm that the RaspberryPi is not stable although I do not have any experience with the arduino. But it makes sense now for me! Regards, Wim DM

Hi LBussy, I'm also a new starter in brewing and for me all this information is a bit to much to read at this moment. I was currently working on trying to make my own temperature controlling system until I found out about BrewPi and BrewPi Remix. As you are far far ahead in this process it...