Search results

The Brewmasters Warehouse recipe calls for 2oz cascade at 60 min. Is this a revision or a mistake?

Use a bigger drill bit to de-burr.

I hadn't planned on it. Of course it will be plugged into a GFCI protected circuit for safety, I guess when I start doing some test runs if it becomes an issue then I will figure something out. I still have to build the vessels and figure out the plumbing. Any suggestions on the plumbing...

Here are the progress pics. There is a heat shield between the MLT and BK, the propane tank will go under the HLT, and the control panel is made from a leftover electrical panel I had. Any suggestions on plumbing this thing?

Resized. Thanks.

Made some progress over the last few days. The stand is done and painted and the control panel is done. I will post pics later.

I think most people use about 25' for a HEX so you should be fine.

Someone was messing with you.

Lets see the guts of the HERMS and control box!

So does the toggle switch go before or after the SSR or does it matter?

There will be a HERMS coil i the HLT.

So will the SSR just control one leg of the 240V?

Hi everyone. I figured this would be a good first post. I've been brewing for three years and have been doing partial mashes on my stove and using a cooler as a MLT. But the time has come to move to all grain. This will be a 2 tier setup with a single pump, electric HLT with a HERMS coil, gas...