Search results

Happy Thanksgiving to yall too. I'm messing with my third box and I'm at an wall. Every thing works except for one led when the switch is on auto. LED works when the switch is on manual. I've checked the wiring...could it be the switch? ETA: nevermind Found it. The switch to d5 had come...

How is this version comparable to RandR+ 's version

@Thorrak any word on this? Just checked and there is still only brewpi remix 2.11 and 2.10 for the revA and recC shields. Also Does the 2.10 firmware have the screen reset feature i have seen @LBussy talk about. I had it running and i knocked it, and the screen went all funky with !,?,/...

I was flashing last night and only saw the remix version 2.11 and 2.10. then Cadibrewers RevC 2.10

@Thorrak have you added the 0.2.12 I2C version firmware to the flash tool yet? I looked to update my minion with the new shield at I2C support but didn't see the right firmware, only the beta firmware you said do not use.

Gotcha. Thanks.

Ok but does that jumper have anything to do with the one wire probes? I'm wondering why they aren't working.

Hey Lee. Been a while since I've posted and it looks like everyone has been a bit baron around here. Question in your new shield. I'm using fermentrack. Should I use the 2.11 firmware? Why I ask is that's what I flashed and I'm seeing the relay but none of the probes. I want to know if I...

Soldered up my 3 boards. Gonna put my controller back together this weekend. So what's the cat Jack for? Nevermind....always go back and read before asking a question. (NEW) Break-Out Board support: An RJ45 to allow for a remote break-out board. This uses an Ethernet cable (which is...

I have the BOM and all the pieces, just confirming the resistor and capacitor designation R1,R2,.... Is the same as the other shields.

Just getting back to all of this. Had a ton of work come up then hospital visits with my wife. So @LBussy Is there a resistor/capacitor list into which C/R slots they go. Im assuming they are the same labels as Cadi's board, just he resistors arent listed.

So it cut out 2 more times this weekend. Im going to hard wire it to confirm if it is the bluetooth module. Then start from scratch with those.

Thats what i thought. well i can only remote into my server cause im at work, but after i ran screen, then reset eeprom and i got a message "Unable to reach brewpi-script. Try restarting brewpi-script." So i got to wait until i get home cycle the power on the controller. This is why i like to...

Oh i know where that is.... is that the same? i was thinking that was different. If i were to reset the EEPROM, would i have to reflash the arduino?

does anyone know where "Reset Arduino to factory defaults" is located within fermentrack?

ok did that and ran screen on the rfcomm and this is what it is printing out.

Thanks Lee. Zio, I believe he said he would upload the files soon. Seems like this is early in the development and just olpit it one place so a couple people can get it together and test it before it is widely available.

Well Lee, I ordered a set of boards and will help you out if you need. So back to the issue I am having. I set my box up and let it run. About 3 days in it deleted everything again. Fermentrack read the same as the screen, no sensors and celsius. But it still had the correct pins and...

Look into fermentrack. All you have to do is run a single code and it installs.

Yes I have one. So reset the hc05 and the adruino.