Search results

I've been using an Igloo FR464 It fits 6.5g carboys. The shelf for the freezer section slide out.

I just finished changing the new model Danby Designer DAR044A1BDD into a kegerator. Its very similar to the older model. You still have to cut the shelving off the doors. The inside seems to be a tighter fit for 2 corny kegs.

im in

Be sure to make a Rocky Mountain Oyster Stout clone to have on tap from your semen tank.

Has anyone built a kegerator using the Danby Designer DAR044A1BDD? Its the newer model of the Danby DAR440BL.

I'll check it out

liked NorCal Brewing Solutions on facebook

Thanks again for all your help. It has really made it much easier to understand.

When I bought the element and temp probe I followed the recommendations here https://www.homebrewtalk.com/f51/rims-dummies-114997/ and bought the Auber Instruments 4" probe with 1/4" din and the Plumbing Supply Model 02463 Screw in Low Density 120 VAC 1200 Watt Screw in Water Heater Element...

After looking over the diagram, I noticed that my JSL-71A timer is the new version. I updated the drawing below. One question about the timer. The PDF shows line going to 9 and neutral going to 10. Does it matter which one neutral and line are connected to? I was referring back to...

Thanks!

I have updated the drawing. I added a timer and alarm. Let me know if there are any problems with the changes.

I used this https://docs.google.com/spreadsheet/ccc?key=0ApGb-vIKLq7FdGtzN3BrY2xZSldORzQ2bHVVX0hzaEE to calculate beer line length. The method used is explained here http://www.mikesoltys.com/2012/09/17/determining-proper-hose-length-for-your-kegerator/

Thanks again, now to order the parts.

Thanks, that make it a lot easier to understand. For the 1k ohm 1 watt resistors do I use these 1k-ohm 1W 5% Metal-Oxide Film Resistor (2-Pack)? And what is the best way to connect them to the fuse and wire? My heating pump is 1500w so that is all I will need. Thanks again for your help.

Yes the element would be independent of pump #2. Thanks for looking at this for me.

Yes thats right. I'm mostly confused where the lines connect at the switch for the 2nd pump.

Based off of this diagram I would like to create a control box for my rims tube element and 2 pumps. I am confused about how to add the 2nd pump and control switch for the second pump. So far my parts list is: 2 x Terminal Strips (4 pole) 1 x Terminal Strips (5 pole) 1 x jumper 1 x...

Would it be possible to get a diagram similar to this using a 120v 1500W element and 2 pumps? I just found these diagrams and they make understanding building a control box much easier. Also what are the parts that are connected the the ground, line and neutral with one wire going in and...

Thanks, the 1/4" mfl to barb adapter stuck out so much I assumed it was the wrong size.