Search results

It's like you are speaking a dif. Language..

BRB parts run:)

Yes, for sure going with the GFI spa panel, and thanks for the link. I was in my local Grovers supply the other day they had them for around 80 (60amp) witch I still thought was a decent deal. My HLT is 30 gallons with a recirculation coil in it for maintaning mash temps. My boil Kettle...

I’m in the process of building my Ebrew system gathering parts. Quick question on this schematic, would a 60amp circuit allow for 2 5500 W. elements to be powered at the same time?

Sweet thanks:)

Noticed the same thing I hooked up my co. bottle to test it initially on an empty keg think it's going to take some messing with to get set up accurately.

Buy a Quality set you will not regret it....

My version of the "spudding valve" Grainger had all the parts in stock...except for the keg attachment.

Is that a Jeweled finish on the control panel? Looks like the finish on the bolt on my Rem. 700's.

Is there a source for the locking nuts on the elements inside the tank?

This looks like it would be neat to try, to have carbonated beer when its finished fermenting is a nice bonus. :rockin: I suppose if you were going to go strait from the cooler into the keg, it would be possible to use oxygen to oxygenate the wart, set the initial pressure to seal the keg...

Hell brotha throw it in boil some water and try it...worst case you have boiling water running out of the motor from the shaft input you get electrocuted and die... best case there's no issue:rockin: disclaimer:) been partaking the home brew this afternoon given the looks form the wify maybe...

works the best for me

+1 All so seems to work better if you use the palm of your hand and put pressure on the back of the bend as you come around whatever you choose to use as your guid....not in front of the bend or it will kink.

How big are your batches? We normally make 20- 25gal sometimes up to 40 depending on how many of us are brewing...I don't normally go threw 1 bottle of gas... A copper kettle would have a little bit of a coolness factor though..gota admit

LMFAO:mug:

I was rummaging around at my local scrap yard this week and found 2 - 7.5 gal sanke's with taps still attached, couldn't pass them up so I bought them, brought them home pulled them apart (both still had pressure) took the ring down to my local bearing dealer and picked up snap rings that were...

Just make it a tippy dump type set up when your done running off you disconnect your hoses bring a trash can over tip it and 90% of the grain is gone, drag the hose over (that you have out to for the cooler anyway) spray the rest of the grain out it's cleaned out.

Moon's Rocky Mountain Brewing Co. - MRM Brewing Co. Moon's Golden Colorado Brewing Co. - MGC Brewing Co. .....:)