• Please visit and share your knowledge at our sister communities:
    Cheesemaking Forum Cast Iron Forum Canning Forum Ceramic Grills
    Espresso Forum Hot Pepper Forums Pizza Oven Forums
  • If you have not, please join our official Homebrewing Facebook Group!

    Homebrewing Facebook Group

Search results

SSBrew - 728
Homebrew Talk

Help Support Homebrew Talk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. Y

    Pull Through (dimpled) TC Ferrules for Soldering Prototype Stuff

    So the same basic idea as your radius faced flanges. Makes sense. Would it be necessary to grind down the inside edge of the soldered flange to allow it to lay more flush against the top of the keg?
  2. Y

    Pull Through (dimpled) TC Ferrules for Soldering Prototype Stuff

    Hey folks, I know the original post is very old at this point but I'm looking for some guidance on pulling a dimple for a larger ferrule. Anyone have experience with this technique for a 4 inch TC ferrule? I don't have any good welders in my area (asking around it would seem the three around...
Back
Top