Search results

gluing down the enclosures for the electrical connection, I use the project boxes they sell at radio shack.

Here ya go. Keg post > Cornelius plug adapter > 1/4" MFL Bulkhead Adapter. This was on my old keezer.. If I remember correctly, I repurposed a 4 inch bulkhead adapter and had a local machine shop cut it in half, ferrule to match, and then all thread it. cost me a me six pack

taps, QD's and temp controller installed

plenty of room for insulation.

Collar is built and first set of hinges is attracted. I plan on making both the original lid and the collar a hinge point

resized the pixels as they were way of. Smoothing sailing now! thanks!!

Plans for the collar. It will over hang by about half an inch on three sides and sit flush in the back.

Awesome! Do you happen to know the units of measurement, I'm assuming its bits or bytes? and the max height and width are in pixels?

So whats the trick? Every time I try to updated a picture the upload manager goes blank and sits there. I've tried different browsers with the same result, Chrome does give me a timeout error though. I looked though the help and support section and I don't appear to be doing anything out of...

6 cornies kegs without a collar and 8 with. My plan is to make a collar, so 8 it is.

picked up a Kenmore 12112 11.1 cu. ft. to replace my Magic Chef which never recovered from a regulator upgrade. Haven't seen many use this model and I wanted a place to collect my thoughts so I thought I would start a thread of my own, nothing more than a wave in the ocean of keezer threads but...

are the perlick's available individually or only as a set?

Im not a professional but... does it sound like the compressor is starting normally or does it simply hum? This could lead to it being a bad capacitor and you can also check your relays as well. I ended up purchasing a "hard start" off amazon to rule out all electrical issues. You cold also...

I agree with dmtaylor, relax and give it some time, if you really wanted to you could give it a quick the fermenter a quick shake if you think the yeast has stalled but nothing more. Also, look at the optimal conditions for that yeast strand, at 70 degrees you might be getting towards the top...

I was dealing with this just last week. Here is the thread if you want to read through it for ideas. https://www.homebrewtalk.com/showthread.php?t=580714

I was fortunate enough to pick up a 7.2cf Home Depot Magic Chef chest freezer years ago and the sadly it has died.. This unit was great because with a footprint less than 3' wide by 2' deep you could get 6 cornys AND a 5lb CO2 tank in it. I found a few of the sizing your chest freezer...

Awesome! thanks for the information!

no worries, buddy! It was a shot worth taking, and I thank you and everyone else for their guidance. Can't expect too much for from a $200 no name Chinese appliance... 8 years seemed to be it for it

An update for all those wondering. I purchased and installed a Supco RC0810 3 'n 1 hard start kit and installed it last night. This replaces the PTC relay, Capacitor and overheat protection relay. This worked flawlessly, I confirmed the compressor started, one copper line in was getting cold...

milldoggy, that's a great setup, where did you find the cleaning adapters for the 425's? Can you post more info on the pump? GPH? or a GPH lift ratio if it says it? Are you happy with the flow rate?