Search results

I have not wired mine yet but will watch this to see what you find out I have the same PID, good luck

Copyright that is just evil! I am currently in Hawaii for business so I will have to drink a few local brews to hold me over! Aloha

I have done nothing but walk past my build in days I feel so bad and now I will be away for almost two weeks for work! Man life sure gets in the way of all the fun stuff at times...first week of April I am on vacation and will make much progress, or at lest tht sis my current plan! All the best...

I mounted both of mine @4.5" from the bottom as measured from the outside of the kegs, it basically boils down to the type of kegs you have so that the gang box is mounted on the flat surface on the outside and allow for the curve inside the kegs. Best of luck.

WOW that's going to be huge can't wait to watch the progress

Just do a search on HBT for these answers this horse has been beat to death...the bottom line is electric is way cheaper, and just as fast if not faster...I am still building my build but it is the way to go IMHO, I am sure others will chime in as well, good luck, all the best.

Yes I am sure that it is only a matter of time until it looks well used! Yeah man just let me know welcome any time...glad to show you what I have done. Well worth the time and energy invested, only 20' but I think it should do the trick...now to finish the panel, so I can start flipping...

Finished and attached the HERMS coil today after the race... I built it from 3/8" ID soft copper tubing, 20' with two short sections of straight tubing and two 90 elbows, flux and solder together and attached to ss with compression fittings looks good ready to finish the control box and begin...

Starting to look pretty good Cidah let me know when you need those flakes!

That is looking great can't wait to see how it all looks completed!

I haven't done much on it the last few days been busy with other life stuff LOL. I am not sure how I will use the SWA but figured that the timer aspect could come in handy, I will have to work on figuring that all out once its up and running. Will keep everyone informed. Thanks.

Yes I know Kal is still a work in progress!!! LOL From Left to Right is the following: Green Master Power Red Flashing alarm w/sound Yellow Emergency Stop Red HLT Red BK PID's: AUBER SYL 2352 HLT AUBER SWA 2451 BK (this has a built in timmer as well) Blue Pump 1...

Here is a pic of what my panel looks like with LED luminated push button switches. Simple, clean, functional, and economical. From Left to Right is the following: Green Master Power Red Flashing alarm w/sound Yellow Emergency Stop Red HLT Red BK PID's: AUBER SYL 2352 HLT AUBER SWA...

I measured mine from the inside wall of the keg to the tip of my element is 13 1/2" hope this helps

Thanks, good point on the conductivity of copper!

I think 50' is too much could only find 20' locally and saw this on Tiber Brew's build thread too. Hope this helps.

I found the post below from Tiber Brew's build...

I just measured mine 4.5" from ground ( bottom of keg) to center of the hole, also wish it was lower but even with smaller single gang box your options are limited. Hope this helps.

Well good luck finding anything over 20' at the local supply places, Home Depot, Lowes, and even the mom and pop shops look at you like your crazy when you ask for 30+ feet...which is what I wanted so I figured 20' it is I think 50' is way too much, I have read others doing it with 30' no...

I think I mounted mine @ 4 inches up from the floor (bottom of kegs) I will measure and check back