Search results

I'm holding out for a 12" one. Still looking.

How much would you like?

Title says it all. Would also take a valve & bulkhead for it while I'm at it. Thanks, Jim

Forgot to mention that detail. Am going the herms route. I was leaning that way - it is going to be the cheaper route. Thanks for the push. Jim

My plan is to build an all-electric rig, something close to Kal's. I have two kegs and would like a third, but I'm cheap and in a corner of the world where kegs don't come by too often. I could get a 10 gal cooler easy enough. I also have a ~6.5 gal stainless pot from my turkey fryer set...

Good point - I hadn't even looked at the cost.

This may belong in the classified section, but figured more people who might have one would see it here. I have some kegs I want to put fittings into on my way to an electric set-up. With so many people having gone down the dimple & solder route, I'm hoping someone has their now-idle dimple...

Has anyone tried PEX as the coil in their heat exchanger? Cheaper, easier to bend, as easy to plumb, good to 200*. I know its thermal properties are nowhere near copper's, but if sitting in a few gallons of water, will the thermal mass outweigh the lack of conductivity? Would need to...

I'd take it if the first buyer falls through. Jim

I made a heatstick and it had been working perfectly. 120v 1500W element. Used it to speed up my HLT and kettle temps, maintain a boil with minimal propane heat, and even heated up a mash. Then I brewed a rye beer, stuck it in the boil, and it scorched and ruined the batch. I then brewed...

PM sent

Not mine, just stumbled across it in my weekly searches. brewing system 4bbl

Figured I'd start a thread to get a 2nd group buy organized. Hopefully ggoodman will give some advice on how to get the ball rolling with Perlick, maybe share who he talked to. Since there was going to be a month's delay, I think we can keep the ordering window open for a bit longer (no...

I'm in for two if a 2nd group order gets organized. Is it getting organized?

Got a problem, looking for some help. Couldn't find a thread through search . . . I've kegged about 5 batches so far with no problems with my current rig. All were done at cellar temp. I just got a freezer and while waiting for my manifold, just put the CO2 tank in with the keg to get...

I'm in Topsham and would be interested. Feel free to contact me at jwb96 at yahoo dot com. Anyone in Maine know of a stainless welder who will work for beer? I have a keg to be converted into a cooler. Thanks, Jim

So if I want to bottle part of a 5 gallon batch and put the rest in a keg, what's the best approach? - prime the whole batch or only the part going into bottles? - okay to only partially fill a cornie, or look for 3-gallon? - if I prime only part of the batch, is the amount of sugar needed...