Search results

Ok the code is now I did change out my PU resistor from 4.7K to 10K to see if that would help and interesting in that it was running for a long time without a failure. Ill keep it running and report back.

pi@beer:/sys/bus/w1/devices/28-3c01d075b9ec $ cat w1_slave 39 01 55 05 7f a5 81 66 1d : crc=1d YES 39 01 55 05 7f a5 81 66 1d t=19562 If t= the number of temperature readings then I can see the t value incresing over time each time I read the w1_slave file so I know its getting readings. Is...

I did a full reinstall and it’s running the updated code but I don’t get any further detail in /var/log/rpints.log. Here are further details Here is the code I am running except Exception, e: log("Unable to Run 1Wire Temperature") log("1Wire Temperature: " +str(e))...

Ok here is the error log message I get. i haven’t put my system in the keezer yet so the temps are in the 75 degree range. Would that cause an out of range scenario? 1Wire Temperature: list index out of range 1 2021-01-10 21:25:39 FlowMonitor I

got it. Thanks my next question is I get regular failures of the temp monitor. I end up with a Unable to Run 1Wire Temperature error in the log. I turned on the debug logging in /python/config to true config['flowmon.debug' ] = True but I don’t see any more details in the log. It works...

thanks that helps but I’m still a bit fuzzy. If I have different valve pins how does brew pints know what valve to open After I tag a card

ok I found those settings after configuring to show valve control. I might not understand the use of the valves though. what triggers the valves to open. Is that the tagging of a rfid card or logging in of a user ? if so if there is no user logged into bpints are the valves are closed? and in...

Another noobs question. I am slogging my way through setting up my Rpints system and making great progress. I got my flow meter connected and working. I will be putting the temp sensor and PIR sensor once I get a breadboard. I want to install a RFID and flow values to keep track of usage...

electronics noob here. For my flow meter 2k2 ohm pull-up resistor, do I install one for each single wire between the 5 volt power line and the signal line thanks never mind. I found my answer

thanks so much. found a 10 pack on amazon. Freshwater only had a 150 pack. Go figure. One more question. any issues or complications if I use these much cheaper flow meters by Digiten. Do I need to update any setting files in Rpints or install any resistors or just plug them into the right...

i am building my rpints system and plan to use the SF800 flow meters. I am using EVABarrier Double Wall Draft Tubing - 4 mm ID x 8 mm OD for my beer line. Can you point me in the right direction for what fittings I need for the flowmeters. Thanks in advance. Also thanks to RandR+ and others...

I would like to install a pass through in a keezer I am building to be able to connect a pump from the outside and a beer line on the inside to clean my beer lines. the idea is To have some sort of quick disconnect on the outside with a corny keg ball lock on the inside. I though I saw...

New All grain brewer here, with a Robobrew on my third brew. It was a blind pig recipie kit. I only put 5 gallons in the fermenter and the OG was 1.071 which is on the high end of the target. I mashed at 151. I calculated a brewhouse efficiency of only 62% I pitched at 65 a packet of...