Search results

By shank "boss" I guess you mean the escutcheon (or flange). You are seeing the side view. From a front view only a tiny percent would be overhanging the 2" angle. If that is not good enough, I suggest measure the flange you want to use and buy the angle to suit. The drawing is to scale for...

I did a CAD drawing, to scale, of the faucet shank installed into my lid. The blue is the metal of the keezer. The lid is overall 1.75" thick. The red is a 2"x2" aluminum angle about 12" long, I would epoxy to the keezer metal skin to strengthen the faucet support. The purple is the shank...

Now I am thinking about installing a tap in the front of the keezer lid. Has anyone done that? Any links? I measured I can easily make up to 1" hole, and have insulation around it. The 7/8" dia shank would leave enough for about 0.3" insulation at top and bottom. I would put a tiny box of...

The better it rejects heat, the better it works. It is designed to reject heat by natural convection, and somewhat by radiation. You are asking about forced convection (blowing) on the compressor. You can blow the fan on the hot sides of the casing where heat is rejected, or on the...

I removed the lid liner and luckily there was a space already hollowed out and it could fit the STC-1000. The hollow may have been intended for an option I did not have, like a light. Below: I removed the lid and the lid liner. I had to cut off an inch of the plastic lift handle. That...