Search results

I guess so. I found that arduino has a setting that lets you choose delete eeprom sketch - sketch and wifi or all data. Mine was set to sketch by default.

Now that is out of the way I have to have a go at adding the OLEDs. Would including the display.h in the bin and adding support for the sdd1306

@Thorrak I found the issue. Due to the esp8266 "riding" old settings it did not connect properly. Brewpiless was running behind it all and owned the wifisettings. I reloaded brewpiless FW then did eeprom clear, when I loaded FW for brewpi it got solved. When having these issues make sure...

@Thorrak I’m using esp8266, nodemcu, connected with WiFi. Running python 3. I’m using fermentrack. Thank you!

@Thorrak - I´m still not able to set any devices. I have tried every solution I have found, but no success. Any ideas?

Now I can not setup devices... From the log it states that when I attempt to add beer sensor: Mar 19 2018 21:29:00 Received applyDevice request, updating to: {"c": 1, "f": 5, "h": 2, "j": 0.0, "a": "28FF96B881160383", "p": 12, "b": 0, "i": 0} Mar 19 2018 21:29:05 Device updated to...

Disregard posts. Found the error...... Faulty user.....

Got it running again, but now I cannot log in. Upon log in I get "Operational Error..... - attempt to write a readonly database". This is on raspberry pi 3 with stretch. Any ideas? I have granted user access, so that should not be the issue.

I also have issues with install both brewpi-esp8266 scrips and fermentrack on stretch. I get error with php on the scripts, and undescribed error with fermentrack. Both on stretch lite.

The only difference is that brewpiless has the "onboard" option of passwords, softAP and it has its own www folder(no need for rpi). Other that that they are more or less alike. You can run BP on wifi as well, just a little tweek.

Too bad! I had a feeling it was that way. I would agree the ease of using fermtrack is great bonus to me. BPL and BP is almost the same imo. Each has its own great and weak sides. I might have to do the change, as I have issues getting BPL online. Any great solution for adding a SSD1306 OLED...

I have the same issue. Fermentrack can not receive data from brewpiless. Any takes on what causes it?

I have checked the gap once. But Ill check it once more. Thank you Dog House Brew

I use a crank handle with my mm3...

I have a mm3 and get waaaaaaay to fine crush, even with 0,065". Anyone who has encountered the same issue? Attached image shows crush with 0,055"

Off course! VPN would solve it. It escaped my mind completely.

1: What do you guys do for access to brewpiless through internett? I have 4 chambers running on brewpiless. And the only way, I found is to open ports to all chambers. Anyone with a better solution? 2: After running for 24h the LCD displays only *^`?=)#/"&!% etc. Noe values. The online LCD...

Im waiting for some nodemcus du build a brewpiless addition to by brewpi chambers. Did you use avrage during calibration? When calibrating it changes values every 10-20 seconds

Hi! I have built two spindles but have som issues regarding to calibration. When I calibrate them I use the spindle conf screen, but the tilt/angles change every reading - even in tap water. How do you handle it? Use the average?

Ill give it a go! I`m a bit curious about the crush I have used since I see a lot of recommendations a lot lower than 0.055". I feel that the crush I have used is a bit to fine.