Search results

No worries! Just wanted to make sure one of a smaller size didn’t get thrown into the mix by mistake. Cheers!

Hey! Those clamps are sized appropriately for 1.5” Tri Clamp fittings. Try taking two of the hose barbs with a gasket in between and putting them together. Should fit perfectly!

The red wires are used to identify which leg of the 240v circuit is being controlled by the SSR. SSRs “break” the circuit of only one leg of the 240v circuit allowing the PID to send an output signal “closing” the circuit to allow power to flow through the contactor and then to the element. It...

There was a delay in the mesh roll for the baskets, so there is a bit of a delay.

Yes, 300 micron restricted the drainage quite a bit more not allowing for as good of a recirculation of the wort. All kettles are SS304.

Hey! These pumps are essentially the same as the original, but chugger has updated the bearing for the propeller on them that does not cause issues when the pump runs dry. These are FDA certified run dry pumps that do not cause issues to the product i.e. wort when ran dry. Thanks!

Hey! The counterflow chiller that will be included in the kit is a single pass chiller so basically the time is takes to drain the kettle depending on how open the valves are. Yes if interested in a 400 micron mesh that can be done. Yes we are updating the site with instructions as we speak...

Thank you very much for your order!! Yes the picture above is the chiller that is included with the kit rather than the tube chiller. Thank you again for your support!

Hello everyone! Pre-orders go live tomorrow! Check our our Instagram page for pictures. Any orders placed using code BIAB10 in the first week will receive 10% off their order.

Yes for sure! And we will still be offering free shipping to Canada on this!

Yes for sure! We will have 3 different options for the pre-order: - Complete kit - Kettle and basket - Kettle only

Almost there! Hoping we can start pre-orders early to mid next week! Pictures of the kit will be out soon. Had a bit of a delay with one piece. We will make the announcement here as well as soon as it is available! Thank you!

Thank you! We are hoping to have the 20gal version soon after the 15gal if everything goes as planned!

Thank you very much!

Hey everyone! Thank you for the interest in our system! So, I know we threw a curve ball with the different kettle size. We were just about to start production on the 20 gallon kettles, but after seeing everyones feedback on here we have decided to stick with the 15 gallon for now and release a...