Search results

thanks. yes it matches the pcb alignment

i loaded the sensor test and wifi reset - it appears it ran, the relay clicked on and off for both hot and cold, no change in the screen - how do i find the log for this?

Maybe I'm readingit wrong but wouldn't it make sense based on those ima-es to have reversed wires vs straight? The pins look eight but the order is backwards on each board? Not sure if it necessarily solves that problem I'm seeing but am I just reading the diagrams wrong? Im stumped on the...

I did above? Or is there another angle needed? I did a double reply

Also resoldering the relevant pins for sda and scl on board 1 didn't fix the problem, still solid boxes. From startup on. Would the board have just bad outputs for those? The software reports out correctly, so the chip itself seems ok. I have another pcb I can attempt to solder components to and...

This looks straight to me the 8266 and level board (hv left, lv right) appear correctly installed based on the pcb labeling. Where else could the issue be? Is a better angle of my assembly needed?

My Amazon order of Rj12 cables says straight but I haven't verified. Thanks.

As of a minute ago, I connected it to my second board and it works perfectly. Still have the same sensor issue. But guessing there's a connection issue on the board in my soldering with my first board.

Ok I got my multimeter working. Seems like I have something up with the power to the sensors? From the bare pins I'm reading 3.3v to ground from the data line, and 2.4v to ground from the 3v3 line. This doesn't seem correct? What did i mix up? The Rj12 jack and RJ12 cord seem to measure the same...

My multimeter is crapped out so I haven't been able to check my soldering quality, but on a dry run after assembling up to the point of the temp sensors, but no lcd and no outlet. The sensors don't seem to register, all I get are lines. The rest of the functionality seems to work. Is this a...

Thanks! I'll see if there might be a smaller pack somewhere

Ah ok. What to order to ensure I have the right thing? Is 4 pin ok? Or do I need 6? How to make sure I'm not inverted? Lol

How this?

Thanks for the quick reply! I I think my issue is buying vertical vs horizontal.

I appear to have ordered the wrong type of Rj11 connector for the pcb, mine won't slot into the board, does someone have a link to the proper jack? The one on github for my board is dead, so I figured any would work. I was wrong. Lol. @Thorrak? Thanks

Thanks. 5v what connector and amperage? Does the power source come withthe d1? I assume not if it's coming from aliexpress

How are the control boards themselves powered? The builds have a power cord for deeingthe outlet and relay circuit, but doesn't seem to cover the controller Power.is that over the USB on the d1 board?

@Thorrak Also, for pcb ordering, I'm looking at the big pcb for lcd, etc. There are ports in the middle that say chan1 and Chan2 hv/lv, how are those wired in?

Thanks, I think I'm understanding now, having the pcb and manual wiring side by side helps a noob see all the same connections on the pcb. The bottom left of the pcb from @Bigdaddyale is where the ethernet connection goes? In the pcb pictured there are little nodes at connection points, is...

Thanks, makes more sense then on what he was saying in the text now. Is there a schematic for the wiring connections to the different components somewhere?