Search results

So I modified the pin assignment for the ESP32 type board. to reflect the pins that Thorrak uses to control his board (i.e. OneWire = 13, Heat = 25, Cool = 26), I disabled the rotarySwitchPin 25 since I am using it for heat). I compiled the config file and uploaded the whole program via Visual...

I don't believe I did. Anyway, thanks for the info. I will see what I can do to get the code running.

I appreciate the feedback. I will see if I can set up a Thorrak_PCB_2 board definition and assign the pins you are using and get it to be functional.

Maybe others on the thread have input. I have tried to use Thorrak's new all in one board with a couple different versions of BrewPiLess (4.3, 4.3.1 & 4.4), no of which seem to work. I have changed the pin out to match what his ne board requires (Heat 25, Cool 26, OneWire 13), I am making the...

AS a follow-up do you have a board design out there that I can purchase that will work with the GX version?

Am I not understanding what Thorrak's board says? Isn't a TFT interface a touchscreen? Here is the specific board I purchased along with the ESP 32 I am using.

Thorrak, I have you new all in one board, if I understand the new pin out you are using GPIO pins 25 for heat, 26 for cool and 13 for OneWire correct? I am using the suggested Lolin ESP32 Pro you linked to on the build page.

I know there is another thread on this subject but I did not see this topic in the discussion. I recently purchased Thorrak's "All-in-One" ESP32 board. I am wondering if anyone else have tried to install BrewPiLess (GX or otherwise) on this newer board? In Vitotai's code you can changed the...

I have been pretty happy with my Solo and conical's, I bought the brew table and had an issue with one of the legs which they replaced without question. My buddy just bought a trio and both the pumps have been nothing but a headache and lead-time on all of it was terrible., pumps are still not...

Will your controller handle an additional 5500W element in the HLT?

Seems a little expensive 🤯

Penguin chillers sells these. https://penguinchillers.com/product-category/fittings/

What about any local brewery that does barrel aging? They might have some of the nails.

Sounds a lot like the Short & Shoddy brew series by Brulosophy, Martin Keen has a lot of pod casts on this very subject. https://brulosophy.com/projects/short-shoddy/

I like the way they have created a single document to build one, when i built mine it was a bunch of single web pages that I had to kluge together. :cool:

Tri-tip today!

Just a question, why the concern about residual sanitizer? Are you flushing the keg with something else after sanitizing? If you are filling with something else, then why wouldn't you just use CO2 to flush that out at the end and be within your required low O2 level? Maybe I am missing something.

terrybond, I don't think anyone is trying to be a jerk to you directly, we often take something and run with it. The two articles I mentioned are a place to start, but as I mentioned they are about aeration of the wort not air locks. Your best bet is to go with the standard fair, a small...