Search results

for me, utilizing a height stagger since a 20# and a ball lock are about the same height. I'd like to set something up to lift the whole bottom up for protection and airflow a few inches and than mount a fan to pull that upward, and have a center pedestal for the co2 tank. Attached a picture w/...

Been thinking about doing this with fiberglass or plastic floor grating but way down on the list

In an effort to get my fast ferment climate controlled (and due to having some scrap wood and stuff which seems to provide all my motivation for creativity these days) I rigged up the following mount for the fast ferment above my inkbird controlled freezer. Since I am a severely inexperienced...

You can turn that cap over and its good to 9.5 collar but I'm at the limit

Sorry I didn't understand what you were saying. Does the end of the pipe look like a flange may have been sheared off?

I didn't attempt because im not replacing the board and it hasn't caused any issues running mine as a fridge. Maybe @KYBLUE will give his a stab if he's replacing it anyway

Per the second picture on the first post of the control board I suspect the BUZ1 is the alarm speaker so that may just need a tactical stabbing

The eraser is a gasket of some sort likely. In order of attempt: Tighten more Replace washer/gasket Teflon tape

Forgot to answer your size question. That's what I measured as clear area inside with lid closed so the height accounts for the lid recession (hopefully). All measurements taken from the top with a tapemeasure so def prone to error. I'll check it out and see if it seems consistent top to bottom.

That's probably what I would/should do and seems like the common solution. Do the lines opening up with the top or the open space behind needed to swing the whole top cause you any issue?

Looks good, one hell of a clamp collection.

Been loading it up inside to see what needs doin. The pin locks are ok but I'm not going to be able to fit a fermenter with them. I think a removable panel would be doable, make it tongue and grove or similar and slide it in and out, but i think anything would likely increase air loss...

Thanks Yes that was a quick reality check. I'd like to build a platform in the bottom with it aiding in that and to lift the co2 tank up to give the double regulator clearance above the kegs. This is also in a room with plenty of exposed steel overhead so i may do a small block and tackle...

several reviews of the 650 on morebeer say it does. "I have three of these. They are the first and only tap faucets I've ever owned. Here's one thing that the marketing brochures don't tell you (but should)... Not only do the flow control levers work great and eliminate the need to adjust...

It has an alarm feature that I was concerned about with external controller because it resets with power and alarms when above freezing.

Thermostat deal seems to be working but has a ~15° temp swing (33-48), but this is empty, i expect it to improve with additional mass inside. It's about 0.25" shy of closing with ball locks and john guest fittings for a keg on the shelf but it looks like it'd be fine with regular fittings. I...

a flow control faucet that totally stops flow

Flow control faucet

Totally new to this but could you put valves on interior side of shank

Search for repeat cycle timer.