Search results

I am looking forward to ESP-32 support but when it arrives I will probably still stay with the good old ESP8266 Wemos D1 mini for my fermenters, simply because it does the job and is incredibly stable. There has not been a single connection drop out with it and when the wifi AP reboots it...

I've ordered a lot and never had a negative experience. Aliexpress holds back the sellers money until you confirm that the goods have arrived in good condition. But be patient, delivery may take 6-7 weeks but 80-90% of the shipments arrives within ~3 weeks.

Thanks. The pumps are great. They need ~22% duty cycle to start but from there they are fairly linear.

There are pros and cons with both but my experience with wireless is 100% positive. I have 6ms ping from BruControl to the Feather which is as good as wired. AFAIK they use the same WINC1500 chip

@rayr87 , @crane I use a hysteresis element in BruControl to control the pressure, which opens the solenoid at setpoint + ON offset and closes it again on setpoint. I am using 0.4 psi as ON offset. Undershooting is not an issue as the solenoid will close instant when at setpoint if the sensor...

Thanks! Brundog is right, I am not using it but when the firmware is ready I'll use one to replace the STC-1000 running my glycol chiller. I will also use when fermenting in plastic buckets. It has only one relay but if you use one for heating and one for cooling you can make them share one...

In the HLT I use this element with this housing and in the BK I use a Blichmann boilcoil. I have cut out the outer sheet and removed the insulation to allow the elements to seal on the inner wall

Awesome!

Hello existing and future BruControl users. I thought I wanted to share how I am using BruControl in my brewery. First of all I must say I am very pleased with the system and concept. It goes far beyond other available brew control systems when it comes to flexibility, stability and...

Here is a demonstration video with the original firmware. Sampling rate seems to be a few seconds max. Not sure if it can be set lower as I have only used it with custom firmware.

Checkout Sonoff TH Can be controlled from a smart phone as is or can be flashed with custom BruControl firmware. Can also be flashed with MQTT firmware and be controlled with CraftbeerPi or basic MQTT

I am thinking about making a SS filter insert for the Hoprocket. Is there someone who can help me with the inside diameter of the rocket and/or the perforated disc?

That would be awesome. It only has 1 MB of SPI flash memory but it can be increased by replacing the memory chip. Pinout for TH10/16 which has temperature sensor connector: GPIO 04 - cooling (soldering needed to access the pin) GPIO 12 - heating (built in relay) GPIO 14 -...

Has anyone successfully ported the firmware to a Sonoff TH10 or 16? Usually I dont need cooling so it would be the perfect fermentation controller for me. http://tinkerman.cat/sonoff-th10-th16-sensors-displays-actuators/

Is there a way to wire the temperature sensors to an ESP8266 and send the values to Cbpi wireless?

Does anyone know if its possible to fit a monster mill hopper on a C&S 320D?

Like this one http://www.ebay.com/itm/Electric-Furnace-220V-AC-Digital-Voltage-Regulator-10000W-Speed-Controller-/121347214684?pt=LH_DefaultDomain_0&hash=item1c40db8d5c ?

Can the DSPR1 be used to limit current to an oversized element so the circuit breaker trip doesn't trip?