Search results

The primary details I would like confirmed are if the OEM nozzle is removable as depicted in the product guide and if so, what connection to the TC cap does it use, e.g. 1/8” NPT, 1/4” NPT, etc. This way if I purchase one and find I’m not satisfied with the pump configuration, I can easily...

Success! Almost forgot I bought a barb fitting, so the photo above does not represent the final configuration. But even with the heavier camlock fitting and cap, it still floated at least 1/4” above the waterline.

Been using spent deep fryer peanut oil. :rolleyes: To the point where I’m a few thousandths away from clearing the draw slug on my 13/16” punch. Was originally planning to suspend a perforated SS disk below the return barb outlet using SS standoffs originally purchased for one of many Raspi...

Thanks, but that’s exactly what I was doing. Unlike my kettle which cut like butter, this was pre-hardened. Snapped both cobalt and standard HSS bits - cobalt bits add up in a hurry. Problem was I was trying to start with 1/16” bits and those couldn’t hold up to the pressure being exerted with...

This weekend I finally got around to trying to assemble a mash cap using this Kraftware 12” tray I bought on Amazon in 2018 - only $20 back then. Six drill bits later trying to make a pilot hole for my Greenlee punch, I gave up. Too bad because otherwise seemed perfect for my 10 gallon cooler...

At Tractor Supply you may need to ask for it. Even though my local store had a product tag on the shelf, they keep the actual product in a stock room. Nice to be able to just grab it locally as needed.

Way to go Delta!

Nice to see a flourish of CBPi V4.0 commits on GitHub this week. Looks to still be a ways off from beta status though.

Are you saying that on the new 16S, you can't do this: Press and hold SET for 3 seconds > IP Press AT/RUN > Sn = Pt Press DOWN or UP to cycle through 10 different sensor types Press SET to save? I can on the original. FYI, the Inkbird sensor for the IPD-16 is a Pt100. 99.99% certain the S...

Forgot to mention, setting bAST = 0 turns off the boil acceleration feature and then the output will always respond directly to the knob setting.

Most likely the EZBoil is in boil acceleration mode. What is the value of bAST (boiling acceleration set temperature) set to in your unit? By default it is set to 200F unless you’ve changed it. When you enter boil mode and your PV (process value), i.e. sensor reading, is less than bAST, the...

64 - IPB-16S - US

In!

Placed an order online tonight after calling the store earlier in the day to confirm a particular part is available. Spoke with Becky and she reported Victor, co-owner with Jay, didn't yet know the status of his home, but that everyone else in the store still had theirs. Also contributed $50...

Jay, my thoughts are with you, your family and employees this night. May you all weather the fire storm knocking on Redding. Know too well the angst. Alt Santa Rosa, CA

iPad2 running iOS 9.3.5 with no issues so far, although yet to run an actual brew session yet.

PM sent yesterday.

From display mode 2 (showing PV and SV values), hold SET for 3 seconds. The display will change to mode 4 and read IP. Press AT/RUN and the display will read SN for sensor type. Press SET and the display will read SC for sensor calibration. Use DOWN or UP to adjust the value of SC to the...

Did you change the sensor calibration setting after switching to the ebay probe? I had to. Then again my solder joints aren't perfect and needs some sort of collar between the cable and the sleeve of the connector that I used - too loose.

Jay, time to order parts for a Thrifty Rims plus the fittings for a mash cap. Please send a coupon.