Search results

I have soldered in the diode in both directions and it won't come out of deep sleep mode. It does report to Ubidots when I press the Wemos' reset button.Looking for errors in circuitry. My other board with the 330 Ohm resistor works fine. I did just order the PCBs though. That is a much...

Which direction did you solder in the diode. There seems to be come confusion.

I would be inclined to try the solder again just to be sure.

I had an issue because I got sent a 10 ohm instead of 10k ohm smd resistor. Sounds like a resistor problem. A photo might help.

Thank you. I'm reading up on it all. Catching up on all the new functionality of brewpiless.

I got brewpiless working (but not controlling) previously. Now with iSpindel integrated this is a supremely useful homebrew gadget. Now my iSpindel is working, this is a perfect time to complete this project and get it working! The new brewpiless firmware compiles, now to flash and integrate...

I think you are correct. I also think I may have a schottky diode on hand.

Not "all good". It only sends data to Ubidots when the reset button is pressed. More investigation required.

Well it is sending data to ubidots. All good.

I could connect direct to the iSpindel to configure it. After it was "configured" it never connected to the wifi router. I will look at the configuration again.

I've got mine put together minus the switch. I crossed the tag ends of the wires where the switch would be. I can flash and find the iSpindel but when I try to connect it to my home network it does not connect. I reflashed a couple of times to set up again. There is something I am missing...

I am waiting on the switch to arrive to solder it all together. I will 3D print the sled at work. That 20g weight looks good. Might have to go down that path.

I worked out flashing the unit. But the clones would instantly crash the Apple. And nothing uploaded to Arduino on the windows machine. Strange. Never had that happen before.

I am now having trouble uploading the sketch using the Arduino IDE. It worked before but now it is just not working. Tried 3 different boards. 1x Uno, 1x cheap uno knock off and 1x cheap nano. The nano was my dedicated flasher. It still works because it wants to still flash STC 1000+ version...

I just changed over from DSL to our new high(er) speed National Broadband Network. New router and new IPs all round. Had to reflash the D1 wifi module with esp-link. I think I fried one unit in the change over, thank goodness for spare. Then had to get the new IP and make it static. Then on...

This is awesome for those who have units they thought they could not flash. I'm going to have to check my non AP 400 controller to see if I can hack it.

I got them from ebay. Chinese supplier. They work very well.

Egg shaped stir bars to replace the one with the rib in the middle. Much quieter.

+ 6 gallons of Dr Smurto's Golden Ale. 18941

You need the temperature of the wort during mash. Everything is dissolved in the water and that is where the biochemistry is happening.