Search results

thanks alot for the help day_trippr!!!!

thanks alot for your answers i will go with a new ssr tommorow!

Im using 220v

I have the same maybe fotek ssr Can i use 5v 10a relay for 1800watt heater ??

3-24 correct but how can reduce the voltage?

I have connect ssr with gpio 23, gnd and from the other side with 220v and outlet

im using direct gpio, do you mean raspberry's power supply? is an 5v 2,1A simple Powe supply

i have connect everything.....i have installed cbpi 2.2 on by the book successfully ssr seems to be open (led light on) with manual action from the Gui but no power on outlet... any suggestion? ????

I had the same problem and it was the faulty gyro!!

Really?? could you ship me 2 or 3 of them???? what's the cost??? if you would like personal contact you can contact on my mail [email protected] as i can see i cant sent you PM

is there any schematic in order to print a board on coper-board instead of breadboard or protoshield? pcb print here in Greece is too expensive.....

finaly gyro has been changed and everything works great!!! :)

Last update** issue with the deep sleep solved with a BAT43 diode i place it as shown in my schema before!! New issue is that tilt shows only 90 and 0 i think that something goes wrong with the GY-521 Gyro & Acceleration Sensor has anyone the same problem? i think that shows 90'and after some...

could you please help me where i must put the BAT43 and with which direction? is the the following schema correct? should i change the following resistor with the BAT43 with direction shown with the red signal?

hi i have the follwo hpg problem woth ispindel, i have already assemble the kit and flash the wemo... i have configure it with ubidots every 15 min after restart the fist signal send to ubidots and thats it there is no signal anymore. after restart and reconfigure same issue acuurs.. any idea?

Yeap it is a clone!! thanks again for your support cheers!!!:mug::mug::mug:

Yeeeaaah!!! i found it Thanks a lot all for your support i have change the port to /dev/ttyUSB0 and finally i have a working flow meter!!!!!!!!

yes already plugged and sketch already uploaded successfully according sketch uploader but on /dev/ttyUSB0

hello again i ve already install everything according all the instructions but i have problem with flow meter when i try to start flow_monitor.py the following error raised Traceback (most recent call last): File "flow_monitor.py", line 13, in <module> arduino =...

wow thanks for the replies tommorow i will config everything ang i will cross my fingers :)