Recent content by wschauberger

Here's just one of a few. Required Delivery - Gpm: The required pumping capacity will be determined by the size of the transfer lines and tanks to be cleaned. If a single CIP recirculating unit is applied to clean lines and tanks, the tank CIP requirement for the largest tanks will generally...

So, I went a head and ordered that pump and it was delivered today. Now I have to design and build the piping and fittings on to my conical. I'm going to also included a valve. I'll look again for the articles that i read 50-60 GPM but can't look right now. Before I put anything in my...

Based on the burtus 10 Design.. but bigger

SS BrewTech 17.5 gal conical

Based on the burtus 10 Design.. but bigger

Some pictures of my brew system

So, i'be bee reading a lot about CIP systems and have read that the sweet spot for GPM (not GPH) should be 50 - 60 GPM. The temp of the PBW needs to be between 100 and 140 for it to not foam. Has anyone used or know anything about this pump...

I just bought a new 5 Gal Ball lock from Austin Homebrew yesterday for 69$ + tax. Used ones are 59$ + tax.

I'm looking for some advise here with choosing a CIP Pump. I've read in the last couple of days a lot of requirements around Pumps and the use of Star-san at temps between 100-140 degrees. Has anyone looked for inexpensive (<$100) pool / hot tub pumps like the one at...