Recent content by Woody_Woody

Update: called Auber this morning, I bought the controllers last year and it’s taken me this long to build my controller and power them up. They sent me a pre paid return label and will swap them out for new ones at no charge. Can’t ask for better customer service than that.

Got the fedex delivery, wired one up then called @ 5:02.... they close @ 5:00..‍♂️ I’ll call first thing tomorrow. I have a Auber SYL-2362 for a mash temp/timer and it works just fine with both sets of probes.

Ok so I ordered 3 new Auber pt100 temp probes with cables and connections. I’m getting the same -22F reading. I’ve went through the manual 100 times and can’t find any reference to a probe setting...

Ahhhh ok its reading 100 resistance across the blue wires and 1000 red to blue... I’m assuming they sent me P1000 and not P100 temperature probes.

I’m building a controller and am stuck on something that should be so simple... thermostat [emoji45]. I’m using EZBoil[emoji768] DSPR320 controller and CrocSee RTD Pt100 Temperature Sensor Probe from amazon. I have the single red wire connected to terminal 5 and the two blue wires on 4 and 3...

Amazing!!! Great job!

Update!! Finally got it finished and serving ice cold beers.

Getting ready to start running wires.

Work in progress...