Recent content by WBCtobe

Not sure if you have already figured something out and I am sure there are better/easier ways but my two ideas are: Put one of these (https://www.brewhardware.com/product_p/npttokegpost.htm) in the lid and then put a gas post on it. The only problem with that setup is you'll need an NPT nut...

So far I have been lucky enough that when the kegerator is in the trailer it has been close enough to power to just run a extension cord. But the trailer was really an afterthought to the kegerator and a lucky coincidence that it fit perfectly on it. Most of the time the kegerator is in my...

of course what kegerator is complete without wheels 49 what to do with this by wbctobe, on Flickr 50 how about a bar trailer by wbctobe, on Flickr 51 patron view by wbctobe, on Flickr 52 bar tender view by wbctobe, on Flickr

On to the Bar Top, unfortunately I do not have any pictures of the rough cut slabs which were probably at least 20 years old. 44 getting ready to attachbar top halves by wbctobe, on Flickr 45 overkill with slats by wbctobe, on Flickr 46 all 3 slats in routed channels by wbctobe, on Flickr 47...

36 insulation with wires for lights by wbctobe, on Flickr 37 lights installed by wbctobe, on Flickr 38 right side lights by wbctobe, on Flickr 39 left side insulation finished by wbctobe, on Flickr 39 left side insulation finished by wbctobe, on Flickr 41 insulation around STC and light...

For the next step I had to bend the refrigeration lines that were around the freezer door so that they would fit in the compartment underneath. Luckily before this next step I ran across someone in the DIY forum recommended that refrigeration lines be bent around a cylindrical object (in this...

21 frame pieces all cut by wbctobe, on Flickr Really not necessary but I used construction adhesive on all joints, including plywood sides just as an added means of keeping the box airtight. 23 door openings added by wbctobe, on Flickr 24 frame put together with bottom by wbctobe, on Flickr...

15 stripped out insulation by wbctobe, on Flickr 16 frame and interior mostly gone by wbctobe, on Flickr 17 side view by wbctobe, on Flickr 19 all insulation and frame removed by wbctobe, on Flickr 20 system check (still working) by wbctobe, on Flickr

Luckily I was going slowly and in my next steps I realized that the hot side of the refrigerant coil went around the freezer door opening. I assume to help with condensation, but I could be very wrong. 14 front view freezer side left by wbctobe, on Flickr 11 top of freezer side (refrigerant...

Well I posted the finished (for the moment) picture in the show us your kegerator thread and said that I would post some build pictures in a new thread so here they are. As it turns out once I got into the project I did not take nearly as many pictures as I intended to so if anyone has any...

A few questions, what are the dimensions of the closet? Also, what are the dimensions of the area you want to keep cold? Not sure about where to buy a refrigeration unit, but I expect it would be pricey. Cannibalizing a refrigerator is no small task, but if you're very careful it can be...

Its on my list to start a thread with my build pictures from this guy but I haven't sat down long enough to do it yet. Hopefully this will provide some motivation. Not the typical set up but pleased with the result.

Finished, until next the next tower is ordered

Build Pictures

That's some good ingenuity! What are you using for your brew kettle?