Recent content by Wake-Forest-Azeotropes

more pictures.... i put 3 layers of insulation between each 2x4 on the top of the collar: Uploaded with ImageShack.us then an additional 2 layers for each side on the inside. And glued each layer together: Uploaded with ImageShack.us more gluing....stupid corners...

I didn't take any pictures when i was really building the collar, i decided on scrapping the lid and just building the entire top part and insulating the crap out of it. gluing the top panel and trying to weigh it down: Uploaded with ImageShack.us Uploaded with ImageShack.us...

so i suppose i'll put a few pictures of my keezer build on here. Its definitely nothing to fancy, and if i could give any one advice if they build one like this....use a table saw if you can. If you do like me, and use a jig saw, you should at least not drink (as much) when your cutting. Rough...

more than moderate consumption of alcohol has also shown to reduce and/or inhibit secretion of testosterone in males, ie the big frat boys that get man boobs after rushing.... Of course, moderation should always be key anyways.... I'm sure you could anchor or tie it down to the bottom to...

what temperature was it when you measured the gravity? I could be wrong on this, but hydrometers are calibrated for a certain temperature, usually around room temp.

seatbelt123, i may have to get with you sometime to check out your rig and how you built it. I'm more of a hands on learner, so as much as i read and research I learn a lot more seeing it in person. Is any of your system automated, or is your heat source just electric?

I recently built my kegerator, so far the costs haven't been (in my opinion, to outrageous). I think a big factor is how much you spend on the freezer, i got a small one off of craigslist for 35 bucks, so that offsets later costs. I've probably spent i the 300 dollar range on mine I spent about...

Hello all, i've been browsing through the forums lately. A few friends from college have been slowly convincing me to get back into homebrewing now that i've graduated college and have the time, and disposable income to brew again. I home brewed for about 1 1/2 years while in college (all grain...

BiloxiBrew, small world, I was born/raised in Ocean Springs. Right accross the bridge from you. Thankfully the beer law has recently changed in MS, but i'm not exactly sure if theres been a homebrewing bill made along with it. Under MS law, it does not state that it is legal to homebrew, but...

could you use two seperate flow meters, one going into the keg from the carboy when its siphoned to count how much is going in, then use a second flow meter on the outlet side/dispensing side to deduct the amount poured from the total to show the current amount/level? I just bought a few...