Recent content by Vincenzo

I meant that I have 2 types , both good quality from BrewBag , of different micron weights , and it doesn't seem to make any difference - I get the same results with either. I initially thought that the smaller 200 micron bag was restricting g flow, and therefore allowing more deposit to...

as in - would a dip tube located close to the bottom help ?

Could the position of the outlet on the side of the brew kettle be too high ( 30mm from the base) and cause a dead spot under this level, allowing all the deposits to settle below this level, and further not allow passing of the deposited material back through the pump and into the grain bag to...

I had a standard BrewBag and was worried that the fine mesh would be restricting the flow and causing a shortage of liquid under the bag, so I bought a new Brewbag 400micron - intended for recirculation :BIAB Recirculation Brew Bag 57L | Craft Hardware. So I don't think its the bag .

I have dozens of brews also - but this only occurs with wheat beers- where more than 50% of the grain bill is wheat - otherwise no issue

I agree with your points- and especially that most BIAB brewers don't see the trub at the bottom of the kettle, but I'm still puzzled as to why more BIAB brewers don't experience the same level of scorching with wheat beers ?

All, I have a question or two about BIAB and brewing wheat beers in particular. I have been brewing BIAB for a few years now and probably have 100 or so brews under my belt at this stage, mostly Neipa, Weissbiers, Saisons and Triples. I recently decided to change from gas burner to electric...

Kevin , did you have any further episodes of scorching ? Have you formed any other theories on this issue ? My experience is almost exactly the same and I suspect the double grind of wheat? thanks Vince

Thank you - this is great , really appreciate it.!

Thanks Bruce, I have a 32A supply, so should be OK there, and I also have 32A sockets for the element and input. In regard to your advice that the black Line 2 be merged with the white Neutral, do you mean that I can replace the Line 2 with the Neutral supply from the mains inlet cable, to...

Sorry I should have included this !

Hi , can anyone advise me of the changes needed to doug293cz excellent diagram for a simple 550w single element / with pump diagram, so that I can use 3 wire 240V European supply ? The diagram shows 4 wire mains input and connections to the power switch and element also include Line 1 and Line...