Recent content by Trisman

Thank you for the response. I opened an issue on GitHub. One mor thing came up today. It seems that at 04:55:39 this morning the logging got an error with the iSpindel. Both, the gravity and the iSpindel temperature are showing zero, which is messing up the scaling of the gravity graph. The...

I got a solution for this one myself. For the unwanted lines I chenged the colorcodes in the Django Admin Panel to #FFFFFF which is white. The lines aren't invisible, but you just see them on the blue and red cooling/heating indicators and when the cross one of the visible lines. Thats good...

Hi, I just upgraded my old Arduino BrewPi to Fermentrack. Since the SD-Card switched to read only mode and new brews weren't logged anymore, I would have needed to reinstall anyway. After finishing the installation and setup process, I have to say: Best decision I could have made! Thanks a lot...

Hi ubermick, thanks for the answer. I will keep in mind that a heater i the best option. I think I will try it without first and look if it will work for me or not. The thing is that I qould have to put a hole in my fridge to get the power cable of the heater in there and I would rather not...

Hi Guys! I have got one question about the brewpi. It seems like the perfect device for my needs, especially since I have most of the hardware to build it already at home. The only thing I couldn't figure out yet is, if I can use the brewpi with my fridge without a heater. Is this possible or...

Hi, after reading about this Hack in a german homebrew forum I thought I should give it a try. So I ordered an STC-1000 from amazon germany, the seller was lerway tech. Shipping from china got me two weeks of hoping to get the right version. And it was the right one! :ban::ban::ban: I have...