Recent content by trfd13

I should say that I do have ball valve on both kettles as well as a false bottom and ball valve on cooler/tun

Looking for ideas for a transfer pump fairly cheap if possible.I'm new to the all grain and am currently using a 10 gallon igloo as mash tun. Have a tower with my keggle heat tank up top to the cooler then to the boil keggle. Just looking for ideas for a transfer pump to go in between the 3. Not...

The 3 1/2' - 4' foot tube comes from the keg

The coil is 3/8od x 5/16id. Using 3/8id tubing about 3 1/2' - 4' clamped over the coil. 50' of coil with the same plastic tubing 2' long clamped to a barb on the shank. The pouring pressure I had set around 10psi

I made a 50' stainless coil that I used for a jockey box. First time I used it it was perfect. The last 2 times used was foamy. I have plastic lines clamped on the coil and also to the shank. Would it be better to use hex nut, ferrile, and grommet instead

on the set it and forget it for 2 weeks what do you set your pressure at?

thankyou to the ones that helped. and to the keg police, they were given to me by a beer rep that comes in to a friends bar, i consider that legal

ok since the police are watching, the kegs were given to me by the beer rep that goes to a friend of mines bar. and yes they are sanke. thanks to the rest of you who dont automatically assume someone is a crook for the help

I am fairly new to home brewing. I just did an extract kit that says 4 days in primary and 4-7 for secondary. Does that seem short

i am fairly new to brewing, just did an extract brew that says 4 days in primary and 4-7 in secondary. does that seem short to anyone.

not sure if i should do brew pots or the fermenter. perhaps i should have mentioned i have a plasma cuttrer and am a welder/machinest by trade.

I have a (store) 1/4 keg and 1/2 keg. Am looking into either making brew pots or fermenter. I am fairly new to home brewing so am doing extract brews. Any ideas or suggestions