I agree. It could be something I'm doing wrong (I'm not an expert) but The most appropriate thing would be to leave it as it is.
When Fermentrack requests that I disconnect the hardware to identify it later (firmware update), what I do is disconnect the USB cable from my RPi so that FT can then...
Good.
I think I made the matter more complicated than necessary: I entered the Django administration to look for the firmware update.
Tomorrow I will test that version (RevC-0.2.13) and let you know the result.
Thanks again
----
EDIT:
Results of the process: I tried to flash the same version...
Well, so I have to assume that I have outdated firmware on my Arduino.
I'll look into how to update it.
What firmware do you have?
Is an Arduino Uno RevC like mine?
thanks for everything
Hello! I have a problem: I am not an expert in this and I am not sure I do it right, I have several doubts.
I installed my hardware approximately 7 years ago, I remember that it is an Arduino UNO RevC Legacy but I remember little else. I have installed VNC server and client on my PC and Rpi and...
Bingo! :)
In any case, I would not want this to involve a lot of work time or effort, it is not a vital thing and I can take into account the temperature difference when programming the fermentation.
I have been using it for several years now so if something works then "don't touch it" (kiss...
What do you mean? I posted stderr.log, stdout.log. Do you mean screen capture?
Ok here is it.
Do you mean other logs? if so, which ones and how can I get them?
TY
----
EDIT: Well, I did it again:
I reinstalled Docker again: ./install.sh -i docker.dev
Then I set beer prove offset to "-0.7"...
Thanks for your effort and help man but… it doesn’t work. In resume: No changes.🤷♂️
I installed twice with no errors.
No offset:
Probe beer: 23.125°C
Probe chamber: 23.813
All probes inside a flask with water.
Reference thermometer: 23.1°C
(So we need apply a -0.7 offset to chamber):
Offset...
Hi man.
Not only has it not worked, but it can't load Fermentrack.
I have attached the installation process with the errors, and also the access screen to my IP (192.168.1.128). it can't access this website and open Fermentrack 😢
——————-
Edit: ok, I thought there was nothing to lose, so I...
Hey, thanks for your fast response 👌🏼
The process I did for this test is: disable the sensor, enable it again by adding a test offset (I.e. -1.5) , see stdout log to check.
Here are the images, I don't see any offset in the log, I've tried it several times.
It is curious that sometimes an...
Hi all!
Could you look at something Thorrak?
Apart from this and addressed to everyone:
Has anyone else had temperature probe calibration problems in Fermentrack?
TY in advance 🍻
Hi all!
I have been using Fermentrack for years and I am very happy with it (rPI3+Arduino UNO). I updated to the docker version without problem but have the probes in a refrigerator and I need to calibrate them since 2 give me different temperatures (a big difference of 0.7ºC).
The problem is...