Quantcast

Recent content by TaylorBrewed

HomeBrewTalk.com - Beer, Wine, Mead, & Cider Brewing Discussion Community.

Help Support Homebrew Talk:

  1. T

    Blichmann 3/8 hp Glycol chiller review

    What is the bent tubing on the back for? I know there is a plug also, I just got mine delivered. I assume its if you wanted to drain the unit you could just run tubing from a pump up to it. There is no nothing in the manual that states what it's for. The bottom of the hole is at 7.5 gallons and...
  2. T

    Festbier BierMuncher's OktoberFAST Ale (AG)

    Brewed this up today. I have been messing around with crush and I got some enzymes so my efficiency went through the roof compared to what I'm used to.. Ended up at 1.065. Looking forward to reporting back in a few weeks to give a review.
  3. T

    Boil kettle condenser - no overhead ventilation needed

    I'm brewing tomorrow so I'll take a picture. There is no tube coming off the steam slayer as I have my electric kettle sitting on a plant dolly and its just high enough to get a bucket underneath the discharge barb.
  4. T

    Boil kettle condenser - no overhead ventilation needed

    Well sadly I don't know my water pressure. But I made the mistake when putting in my weldless fitting on my kettle a little too high and didn't account for the dip in the kettle lid. Although when I noticed the issue on my first brew with the steam slayer I threw some weights on the lid and...
  5. T

    Boil kettle condenser - no overhead ventilation needed

    Hi I just purchased a steam slayer from brewhardware. After my first time using it i was only getting a discharge temp of around 100 degrees on a trickle from my faucet using a 9 gph mister. Is this to low of a temp? Should I try the 6gph that I have instead?
  6. T

    Wisconsin Keg Tags

    @zbrewcan these be made with date kegged and then below IBU and Abv?
  7. T

    Picobrew Z

    Do you have a link to this deal? I never got a email
  8. T

    New Anvil Bucket Fermentors

    Has anyone seen if the Ssbrewtech mini or 7 gal bucket lid would fit this? I have a idea but would prefer to us the flat lid instead of the Anvil dome lid.
  9. T

    PicoBrew Zymatic

    This may have been discussed before so I apologize. How is every measuring pre and post boil wort volume for efficiency? I just got the Z and would really like to dial it in.
  10. T

    Brewometer kickstarter thoughts - digital bluetooth hydrometer

    So last night I bottled my first batch that used the brewometer. At end of fermentation I was sitting between 1.014 and 1.018. When I cold crashed it got down to 1.08 to 1.011. When I did my final readings the brewometer was a degree higher in temp and .004 higher in gravity. Finished beer was...
  11. T

    Brewometer kickstarter thoughts - digital bluetooth hydrometer

    That must had happened during the night. Your solution fixed it. Thanks
  12. T

    Brewometer kickstarter thoughts - digital bluetooth hydrometer

    So my unit stopped sending information to the cloud last night around midnight. I suspected it might have been battery or my phone that I use to grab this information died. I went to my basement this morning where my chamber is and it was still sending information to the phone. I emailed the...
  13. T

    Brewometer kickstarter thoughts - digital bluetooth hydrometer

    They have to be. Everytime one changes the other does as well on my brew.
  14. T

    Brewometer kickstarter thoughts - digital bluetooth hydrometer

    Ok just got mine today and have to admit I was sceptical about needing to using a phone or tablet to upload and log continually but I have to say I'm loving it so far. Good thing I held on to my old phone. My son is not to happy loosing out on a toy but in a few days he will forget about it...
  15. T

    Brewometer kickstarter thoughts - digital bluetooth hydrometer

    I wish this thing would just connect to a network and upload on its own and by pass the whole need a extra phone or tablet to generate continuous logging.
Top