Recent content by sleepy_brewer

Thanks guys!

So I am using my Inkbird on an extra Kegerator I have in order to use as a fermentation chamber. I am fermenting an IPA so I need to keep the temp in the mid-60s. Should I plug the fridge into the 'Cool' plug or the 'Heat' plug? How should I set the fridge? Set it at the coldest setting...

Nice. Should be brewing an IPA this weekend and looking forward to my first temp controlled ferment. Normally I set the carboy in my basement....which stays between 72-78....but on my last beer I think that was too high. Tired of banana beer.

Thanks guys....after re-measuring it will fit even with the airlock. Measure twice, cut once!

Looks like this would work, but not sure how much height this would.

Is there a way to connect a blow off tube to the BrewBucket? With the airlock I don't think it will fit in my fermenter. If I could do a blow off tube I might be in business.

Thanks! Too tall for my application. :(

How tall is the FF with bottom ball and top air lock on it?

Thanks Bobby. I found a 1/4" npt to 3/8" barb so hopefully that will work out.

I think this is the correct size thread: http://www.kegoutlet.com/swivel-nuts-treaded-to-barbed-for-beer-and-gas-line.html Hopefully someone can chime in. The swivel nuts on my gas disconnect is a different size than will fit on the CO2 regulator....threaded side.

Hmmm....so does anyone have a link to one that would work? I am looking on sites but not sure what measurements are for which. The threaded end I need fit 1/4" female thread and the barn end needs to fit 3/8" or 5/16" tube. Thanks.

I went to Lowes and this thread worked so I guess I need 1/4" to whatever size barb I need.

I need to find the correct size of fitting that will screw onto the thread pictured. Sorry if I am not using the correct terminology....so the barb I am not as concerned about as much as the female end of the fitting

Great looking beer. Cold crashing for the first time now and adding gelatin in a few days and will be kegging next weekend.

Thanks. So should I just set the Kegerator to 'max cooling' and let the Inkbird do the adjusting?