Recent content by shoengine

First time fully loading!

I have a brew slated for next week, so I can check it under load then.

Nope, regular ol' barb The fitting just has to go past the barbed section.

You can get duotites that fit over barbs, fyi.

I meant post these earlier. I don't have links to them but my buddy bought everything off Amazon. @sibelman Do you have a video of the whine?

I just gave the three I had away to my buddy who makes mead. I'm make sure to tell him not to grease 'em up before moving them.

I liked the design of the Gen 1 BrewBottler better.

Ran out of Saurian brandy.

That's a steal for $90!

I'm checking on this...

I can't speak to the torque requirements. I did mention to my friend that finding a motor that could run slow and put up with the milling was very difficult. I've milled with it twice so far and both times it worked well, with no struggling. I usually start my mill before dumping the grain in...

What clamp do you need info on?

Designed and printed a motor housing and spacer for the mill.

Hey, no fair redacting the computer password you leave on the keyboard!

It's bound to happen at some point. People are just people. We've offered suggestions and nothing works, so I'm assuming this is just a way to complain.