Hi Gonefishing, I got it off Ebay. I think it was the same seller as the inkbird PID's but can't be sure. I was being a bit OCD and wanted them to match. It works fine. I have an alarm and a big reset button connected to it. I think, like the PID's, that the wiring diagram is a little different...
Mine didn't seem hot either. So who knows. I also changed the control cable from the PID to a screened twisted pair. Not sure if that helped but it was the spec'd cable.
Had the same problem with eBay foteks. Probably a knock off. They're on the list for an upgrade. Light would flash on and off but it wasn't actually switching. I added a computer fan to the side of the cabinet and the problem has gone away for now.
Thought I should do this properly instead of at 5am on my phone waiting for a 2 year old to go back to sleep.
Started about as 18 months ago when I had the misfortune to come across Kals Electric Brewery site. Massive thanks Kal. I've made a few mods i hope he will understand!
I went for a...
Some older photos and newer. Started with those little tan pumps. Changed to keg king ones now and added recycled ss bench. Kal clone but I ran all the wiring within the frame of my brew stand. Didn't like cables everywhere. Pots and pumps plug into sockets below the bench. Also no ammeter or...
I have the same issue. Not boiling over just boiling a little too hard. Did you find a solution. From the manual and playing around it looks like the manual setting only covers on or off, no duty cycle. I think you can set a general max output somewhere in the setup but this would be a little...