And that was the issue. I live in Denver (@6000 feet) and on the DSPR 120, my boil was starting at 190. I had to adjust the bAST from the default of 200 to 190 as the boil was running away from me and I could not control it as it will push 100% on the element until it met the bAST number...
FIXED - Issue was due to lack of knowledge... :(
Here is what I figured out:
Thank you to ZmannR2 on making my brain look at troubleshooting the DSPR120.
- After calibrating the temp probe in ice water, I was able to get the EZBoil setup correctly with the temp.
- Going into the...
Hello Everyone~
I had not been able to update until now as I have been busy with some after-hours work and could not get the time in to test.
I just finished testing with the SSR and here are my findings:
Go to 14:00 in my video I posted yesterday and you will see the test of the SSR with a...
Here is the deal - I did some additional testing after I wrote my last post.
I did a basic SSR test with a lamp of 40 - 100 volts.
I put the lamp inline to the SSR and then used a 9 volt battery to activate the SSR.
Guess what? The SSR works. Now I am really confused.
:confused:
I...
On the DSPR120, the "power out" LED is NOT on. The SSR does not show the LED on. The circuit is still being made as I read 240v at the element connector. I do not have the element hooked up at this time. Oh, and yes, the SSR responds when the "power out" LED is on and off on the DSPR120...
OK - I tested with disconnecting the 3 or 4. The SSR LED is out and the connector for the heating element is reading 240 volts. I do not have a heating element connected.
Hello Everyone ~
I have recently built a control panel for my HERMS brewing system and having an issue with my Solid State Relays. Here are the specifications of the setup:
- Dedicated 240v 30a circuit to garage
- Circuit terminates to a Spa Panel (GFCI Breaker) with recepticle for control...