I built a keezer/kegerator behind my wall mounted taps. I use the Inkbird 308 for the temperature control, but I find the temperature swings create a lot of water build up with the "freezing" and "thawing" periods. Any suggestions on success people have had with the controller to limit the...
Here is a link to the blower I bought. It is very similar to the one linked above.
https://www.zoro.com/dayton-blower-12-cfm-115v-008a-3340-rpm-1tdn2/i/G2667725/
I actually used a washer discharge hose as it was more flexible than PVC when it is cold. In place of the flange I took the fan...
Thanks everyone for the suggestions, I purchased the ITC-308 off Amazon and it has been working great since Thursday.
@IslandLizard Haha the number of taps was actually a legitimate dillema I had during the planning process. Decided on three so I could have a standard lite beer, then have a...
I put my keg back in last night and let it settle through the night to get a more accurate gauge if there would be foam. Tested it out this morning and the first poor came out perfect so it is a success! Granted my PVC run is not that long so that could factor in as well. Thanks again for the...
Thanks everyone for the help. I purchased a ITC-308 on Amazon and it came yesterday (Prime is a great thing!). I got everything set up last night, and allowed the freezer to adjust overnight. I went down this morning and placed my probe in a bottle of water that had been cooling to get a more...
This will be my first time using this device on my first keezer build where my kegs (store bought, not homebrew) were freezing. I am using a 14cuft freezer, is there a compressor delay time you can suggest for this? Also should I have my freezer setting up all the way using this device?
I recently completed my home bar build,and used a 3 tap through the wall keezer build that @martianpc posted on here. It turned out great, but the first keg I put in the keezer froze after a day or so. I have the freezer on the lowest (warmest) setting without putting it on zero which the...
I recently completed my home bar build, and built a 3 tap through the wall keezer system that @martianpc had completed and it turned out great. My only issue now is that the first keg I put in the keezer froze after a day or so. I have freezer set to the lowest (warmest) setting with putting...
Great set up! I just finished my set up (pictures to follow) and replicated yours as closely as possible and it turned out great! :mug:
The one issue I have now is that my first keg froze after a day or so in keezer! I have it down to the lowest setting possible, but is still giving me...
Great set up, I actually just finished my set up(pictures to come) and I tried to replicate yours as best I could and it turned out great!:mug:
So I tapped my first keg a few days ago and it was working great, but after a few a day or so the keg froze! I have the keezer down to the lowest...