My guess is the smaller fitting is your inlet and the larger is your outlet. That way you don't have any flow restriction. Also, those both look like 3/4" NPT threads. I would adapt them to a 3/4" NPT to Garden Hose (One male and female). McMaster Carr has fitting too.
As for the total length...
Hello all! So I'm probably being over the top on this but... I received my Wyeast 1332 yesterday afternoon and made a proper 1 liter (per Mr. malty) starter for this weekend's brew of Northern Brewer's Caribou slobber!! I've been a little worried about the heat during travel for the yeast. When...
Only thing I can think of next is the really look over your Ball lock/Pin lock. I would make sure that it's holding and not leaking gas. I would also make sure it's not doing sorting strange like "checking" the beer in the line and not letting new co2 in the line when it's not flowing.... Really...
I'd try the Oxy since you have it or PBW. I've just read that BLC has a higher concentration of the good stuff to help clean and clear out your lines. But since he's our new lines, try the Oxy and Starsan..
I've read that some people use John Guest fittings on the kegs. This way they can VERY easily swap lines between pin and ball anytime. I would just use what you have and get the fittings. It will be probably the cheapest. I'll try and fine the forum that talks about the JG fittings. I know I'm...
I'm considering purchasing the same one in the next few months. My plan is to have a secondary regulator with three ports. I want to drink out of two of them and carbonate/age on the other.. Something like this person did.See picture.
my question is will I be able to fit everything in there with...
Thank you so much! I know that was your picture I for some reason couldn't post directly with your picture so I had to save it and then post. If you get around to it, a few additional pictures would be awesome! But the biggest question I had was to make sure that you had all three kegs in there...
I'm considering purchasing the same one in the next few months. My plan is to have a secondary regulator with three ports. I want to drink out of two of them and carbonate/age on the other.. Something like this person did.See picture.
my question is will I be able to fit everything in there with...
I'm trying to set my kegerator up just like yours. I am getting a two faucet kegerator that can hold three kegs from beverage factory. It looks like you may be doing the exact same set up I have mostly.
Can you post some pictures of how you have the inside set up? Are you able to fit your...