You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
-
That’d be awesome thanks
-
Battery monitoring circuit working for me, it would be a slightly simpler build for the floaty of pin 32 was used for the battery...
-
I just lay mine flat on the table and it enters configuration mode. Sometimes I might have to push the reset button first.
-
I’m also going to add the battery monitor while I have the soldering station setup. Does the 470k resistor connect to gnd on the esp32...
-
Actually never mind, if I calibrate it with the gyro facing flat it does work. My calibration was with the board perpendicular as it...
-
I just soldered up a 2nd one to check for a hardware issue and it’s exactly the same as the first one. The gyro is a
GY-521 MPU-6050.
-
Hmmm, maybe I’ve a faulty gyro then or something.
-
Thanks, I just flashed a new version reading the angle using the other axis but it resulted in similar behaviour. When I move from flat...
-
Thanks, that’s most likely what I’m seeing then. Mine is orientated like this
-
I updated my floaty to 1.4 today but I’ve noticed when I place it on its cap it thinks it’s at around 60 degrees. If I tilt it it seems...
-
Loading…
-
Loading…