Recent content by Robhansen

Yes, I use a 2" triclover. I was thinking about using a screen tube that would just push into the neck of the keggle and bottom against the 2' X 1/2" adapter.

Sorry, I should have explained better. Hops go outside of the tube, just like no screen at all. The draining liquid goes thru the screen on the way out.

I have bottom drain electric keggle. I wonder if small diameter (the same as the ID of the keg neck) screen tube standing straight up like the original spear would clog badly during draining. It will clear my heater and allow the use of the immersion cooler. If it would work, it should keep all...

Cool,I'm in!

Awesome stuff!

I'm in! thanks

Where are you in Indiana?

Count me in!

I'm in also!

Great prizes!

And I thank ya for that!

I bought a 50a range cord at Lowe's to put in my panel. I'm in the RV business,so I have a few 50a RV extension cords around. The cord from Lowe's is much smaller in outside diameter than the RV cord, but they are both very stiff and hard to handle. Got ahold of some 6/4 soow cord and it is...

Thanks for getting the research done on that! I had myself convinced that I would have to back the set point down every time I was done with a heater.

Actually, I'm using the 2362 controller. I didn't think it used "fuzzy logic". Anyway, I registered on Auber's forum to ask them. Waiting on them to complete registering. I do thank this board for all the knowledge I've gathered throughout my build!

Thanks for all the input on this! I thought I'd seen that the PID continues to learn. We'll have to wait and find out what Auber says!