Recent content by RedHotS4

Update from my end -- talked to MicroMatic today. They told me that tap handles with 3/16" lever slots on them are provided solely by Guinness with attached faucets through their distributers to bars and restaurants only. In fact, she said, a bar or restaurant can't even buy one, they have to go...

Did you buy your gold MM faucet new and independently of the tap handle? Or was it a package deal that came with the faucet and tap handle together? Btw I’ve tried to get ahold of MicroMatic to ask them these questions but can’t get anyone to get back to me.

The tap handle shown doesn’t thread on. To install it, you remove the set screw holding the lever in place on the faucet (the piece with the threads on it) and slide the tap handle over the top of the faucet spindle and replace the set screw. if you have a JESF-4 close by, how wide is the level...

When you bought that faucet was the handle Included or did you just buy a JESF-4 and put your own handle on it? Did you buy it new?

That would work for my handle! What model Micromatic faucet is that, do you know? The stout faucet I have is a less-expensive model I picked up on amazon so I’m not too concerned about abandoning it for a better one.

Sure. In the right of the photo is the base of the tap handle. The slot shown is 3/16” wide. On the left is my stout faucet with the lever still installed. In the center of the lever you can see the top of the faucet spindle that is raised and lowered when moving the tap handle. The top of that...

Afternoon everyone. I'm converting my 8x12 storage shed to an Irish pub. More on that later. I've got a triple kegerator on the way and recently ordered a Guinness tap handle and a stainless stout faucet (Amazon...