Recent content by pvasey

Actually the reading variance is more my inability to hold the multimeter steady. After re-checking all are 100ohms except the tip to center and that is like 98 or 99ohms which as I understand it should be zero.

no, it's molded to the pin and if I try it will probably screw it up and I don't want to void the warranty.

I attempted to respond to your comments but accidentally posted it as a new post rather than a reply so you may not receive a notification.

By the way the probes are pt100 rtd's

If you look at the earlier posts in this thread my equipment is exactly the same stuff, a Ssbrewtech RIMs unit and boil coil used with Aubers DSPR 120 and 320 PIDs. In the earlier posts the gentleman got his wires coming out of the female receptacle to the PID mixed up and once they got that...

I believe it would if there a couple of bare wires touching. I'll post a couple of pictures tomorrow.

. I have been reading your posts with lazypasta from earlier last year. I have the identical situation with the exact same equipment except that I am using the 3.5mm female panel mount receptacle. Also I am familiar with the continuity tests and here is where I am having a problem. I have...