Recent content by petewa

PERFECT! thanks!

Doug great work on the new version... love it. The only issue i am having is when i try to add in a switch. once i add it it will not allow me to shutdown the app and i get the following dump to the console. I then need to kill -9 the app. INFO: CONFIG READ COMPLETED***********...

I have been using ON-OFF-ON toggle switches... so i can have an off position, an on position, and an auto position for the wifi control aspect. This also gives you a quick and easy backup plan in case the controller dies on you.

I like that board!

when i first load my browser i also get that 12 4 on the temp probes... but once the page fully loads my temps fill in properly... do your temps stay with 12 4?

Thanks... i ended up backing down the kernel (3.18.x) down to 3.12.x. I will also try your fix. Thanks again

here is a 10 gallon beer i have just made....

just wanted to see if anyone has seen this error before when trying to add volumes. Jan 03, 2015 2:51:42 PM com.sb.elsinore.BrewServer serve INFO: URL : /getstatus method: GET Jan 03, 2015 2:51:44 PM com.sb.elsinore.BrewServer serve INFO: URL : /getstatus method: GET Jan 03, 2015 2:51:45 PM...

WOO HOO... that was it... THANK YOU SO MUCH! i owe you a beer!

DAMN... there is the missing link... thanks... let me try that now. THANK YOU SO MUCH! Peter

my understanding is that the RPI does not have any analog pins and that is why i need to go through the ds2450. that is what i did. humm

I must have miss understood something somewhere along the line... thought you said the ds2450 had to be plugged into the 1wire bus...

wait... gpio4 is my 1 wire bus. that is what the ds2450 is also plugged into. then i have the volume sensor plugged into port A and the ph sensor plugged into port C on the ds2450. what am i missing here then?